APPENDIX A SOFTWARE INSTALL..................................................................................................9
APPENDIX B INSTALLING WINFAST NAVIGATOR FOR POCKET PC...................................13
APPENDIX C TEST REFERENCE FOR ONLY................................................................................17
i
.
ii
.
1. Introduction
1.1. Overview
The Leadtek 9537 Wireless GPS receiver is a Global Position System Receiver with Bluetooth
wireless technology. This wireless GPS receiver allows you to receive GPS data on mobile handheld
wirelessly. By sending GPS position data over Bluetooth, you can position the receiver for the best possible
reception all without wires. The advent of wireless GPS receiver will become the next level of GPS
receivers.
The Leadtek Wireless GPS receiver integrates Bluetooth module into GPS device. It shows the
high performance, low power consumption, easily portable, rechargeable & removable battery function and
wireless data transmission. If you have a Pocket PC or other portable devices enabled with Bluetooth
functi on, for example iPAQ 3870/3970 and SONY Ericsson T68 mobile phone, you can take advantage
of your device’s Bluetooth capability to wirelessly add GPS positioning technology. When you choose
suitable navigation software, you can apply to personal, vehicle tracking, and marine navigation.
If you use this wireless GPS receiver, you will ignore the messy cords and antenna and add the
portability of your Pocket PC. In addition , This wireless GPS receiver can change the exhausted battery to
full battery like battery of mobile phone.
1.2. Main Features
u 12 Channels “All-In -View” Tracking
u Position accuracy of 10 meters 2D RMS
u Cold/Warm/Hot Start Time: 45/38/8 Seconds
u Reacquisition Time: 0.1 seconds
u RF connector for external GPS antenna
u Support Standard NMEA-0183
u Support Trickle Power mode Power Saving
u Compatible with Bluetooth devices with Serial Port Profile (SPP)
u Superior Sensitivity for Urban Canyon and Foliage Environment
u Small, sleek, and lightweight design easily fits in your hand
u Two LEDs indicating Bluetooth and GPS activity.
u Lithium-ion battery lasting full working day typical use
u On/off push button
u Dimension: 1.77” x 3.27” x 0.71” ( 45mm x 83mm x 18mm )
Operational Power 3.3VDC±10% (from internal Lithium-Ion battery pack)
Input Power 5VDC±10%
Battery Source Rechargeable and removable 900mAh Lithium-Ion battery with 5V DC
input charging circuit.
Battery Charging Full charge 3 hours
Backup Power 3.3V ( internal on board rechargeable backup battery)
Operational Current The device is enabled by Lithium-Ion battery only.
GPS position(patch) GPS not position(patch)
BT connect BT not connect BT connect BT not connect
- - 2
.
Current
Continuous
mode
consumption
95~105 mA
Trickle-power mode
5sec
15--
65--
-->65m A
1sec
-->15mA
98~108mA 65~75mA
1. Battery is not charging state.
Remark
2. The current consumption of active antenna is 21mA
Typical Operation Typical use 6- 8 hours
GPS and Bluetooth fully active 4.5 - 6 hours
2.1.7 Main Interface
Connection: Communication via Bluetooth Serial Port Profile(SPP)
Protocol messages NMEA-0183 Version 2.20 output protocol
Operating temperature range -20ºC to +60ºC (-4ºF to 140ºF)
Battery discharge -20ºC to +60ºC (-4ºF to 140ºF)
Battery charge 0ºC to +40ºC (32ºF to 104ºF) Short period storage temperature (< 1 month) -20ºC to +50ºC (-4ºF to 112ºF)
Long time storage temperature(>1 month) -20ºC to +35ºC (-4ºF to 95ºF)
.
2.73 oz / 78g (with chargeable battery)
Antenna connector MC plug -Note: The internal antenna will be disables when an external
antenna is connected.
Power connector ψ2.1*5.5*9.5 ( The connector look the same as the DC jack of
iPAQ 36/38 series PDA. )
2.4. Accessories
Mains Adapter Mains Adapter for charging. Supports 110V-220V. Multiple
- - 3
.
AC plugs provided for US, UK and Europe.
2.5. Regulatory Standards
Operational BQB
Safety CE
Electrical FCC Class B, ICES-003 Class B, E-Mark
3. Applications
Leadtek GPS 9537 Bluetooth GPS receiver is a high performance, low power consumption
product. The product applications are as follow.
u Vehicle Tracking & Location -based Services
u Personal/Portable Navigation
u Car Navigation
u Marine Navigation
4. Operation
4.1. Hardware Description
- - 4
.
The Bluetooth GPS has two LED light which each has two colors. One is GPS & Charge status
LED, that is named LED 2, and the other is Bluetooth & low power status LED, that is named LED 1. The
status table of LED shows as follows:
<State Table of LED>
LED1
BT & Low Power LED Description
LED1 Color and Action Bluetooth Active Low Power
Blue Flash Yes No
Purple–Red Flash Yes Yes
LED2
GPS & Charge LED Description
LED2 Color and Action Battery Charged Position Fixed
Dark No No
Green Flash No Yes
Orange Yes No
Orange-Red Flash Yes Yes
<Note1>When the Bluetooth is active and LED 1 lights, it shows Bluetooth RF function. As long as the
Bluetooth RF is transmitting the LED light will flash. When Bluetooth doesn’t connect the other Bluetooth
device, the LED 1 will be flash periodically. Therefore, it means that it broadcasts message to connect the
other device with Bluetooth function. If it connects the other Bluetooth device and transmits data, LED 1 will
flash very quickly and look like bright.
<Note 2>When the battery is charging, LED 1 will show purple-red color and flash. The reason that
Bluetooth is working cause LED 1 purple-red color. If the GPS receiver go to the end of charge, LED 1 will
show blue color and flash.
- - 5
Loading...
+ 17 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.