LEADER PREMIUMS AB0011 1 User Manual

Nebula Wireless Charging
Pad with Integrated 2-in-1

Cable

Instruction Manual

AB0011

Features:

1.

USB Cable

2.

Silicone Cover

3.

Wireless Charging Pad

4.

2-in-1 Charging Cable

5.

USB Cable Storage Compartment

What’s included:

1 x Wireless Charging Pad
1 x Instruction Manual

Total Input: DC 5V/2A

•
Wireless Input/Output: DC 5V 1A/1A

•
Cable Output: DC 5V/1A

•

INSTRUCTIONS:

1.

Charging Mobile Devices:
Ensure that your phone or tablet supports
wireless charging. It will be listed in the

the last page of this manual).
Connect the wireless charging pad to a
USB adapter with the integrated USB
cable (1).

a.

Place the enabled device on the surface
of the wireless charging pad. Device will
automatically begin to charge.

b.

Or/And insert 2-in-1 cable(4) into your
desired device port to charge through
wire cable.

*

Note: To charge devices, use only the
accessory cable or the cable included with
your own device by the manufacturer.

SAFETY PRECAUTIONS:

Read all the instructions before using the
product.

Do not use on an aircraft or in a hospital.

1.
To reduce the risk of injury, close

2.
supervision is necessary when the product
is used near children.
Do not expose the device to any moisture.

3.
Do not use the device in excess of its

4.
output rating. Overloaded outputs above

Do not use the device if damaged or

5.

exhibit unpredictable behavior resulting in

Do not disassemble the device. Take it to

6.

or repair is required. Incorrect reassembly

7.
excessive temperature. Exposure to
extreme heat may cause explosion.

8.
repair person using only identical
replacement parts. This will ensure that
the safety of the product is maintained.
This device is not a toy.

9.

10.

Do not overcharge Phone. Unit may get
hot with excessive use. Remove Phone
when it is fully charged. Never charge for
more than 7 hours at a time.

11. Attachments on the back of your phone

can impede the effectiveness of the wireless
charger, and lead to overheating. Please
remove attachments from the phone before
charging on this device.

KEEP OUT OF REACH OF CHILDREN***

***

FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:

‐‐ Reorient or relocate the receiving antenna.
‐‐ Increase the separation between the equipment and receiver.
‐‐ Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.
‐‐ Consult the dealer or an experienced radio/TV
technician for help.

FCC Statement:

This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
This device may not cause harmful

(1)

interference, and
This device must accept any interference

(2)

received, including interference that may
cause undesired operation.

Warning:

*

approved by the party responsible for
compliance could void the user’s authority
to operate the equipment.

MADE IN CHINA