LDIC LD3511-8, LD3511-4, LD3511-6 Datasheet

LD3511-XX
4, 6, up to 8 Channel
+5V, +8V GMR Head Preamplifier
Samples Available
version 1.0
DESCRIPTION
The LD3511-XX is a high performance BiCMOS, read/write preamplifier IC, designed for use with 4-terminal GMR recording heads. The device provides a low noise GMR head amplifier, DC bias current control for GMR head, 8V thin film write driver, write current control to the write current drivers, thermal asperity (TA) detection and correction. Fast recovery mode can be also programmed to put the chip faster in read mode from any other existing modes. The device is programmable for read gain, write overshoot and undershoot, fast recovery, GMR resistance measurement and thermal asperity threshold level. The device features multiple channel write. Half or all of the heads can be simultaneously selected in the servo write mode. Features and thresholds are controlled through a 3-line serial interface with readback. This product requires a 5V & 8V supplies. This device also provides PLR circuit, and on-chip temperature monitor function. This device is available in flip-chip or TSSOP 30 & 38-Pin packages.
FEATURES
Current Bias/Current Sense Architecture
Operates from 5V and 8V supply
3-line serial interface with readback (3.3V
CMOS compatible)
Power fault protection
Power management modes
On-chip temperature monitor
External reference resistor (2Kohm)
Head unsafe fault detection for both read
and write
Unselected read/write heads at GND
potential
Fast recovery mode
300MHz Read Bandwidth
One side grounded input, fully differential
output
Read frequency boost
Programmable GMR resistance
measurement mode (5-bits)
Programmable GMR Pinned Layer Reset
(PLR) pulse circuit
GMR bias current range 2-9.75 mA (5-bits)
GMR resistor range = 25 to 75
Programmable read gain = 225 V/V or 300
V/V
Input equivalent noise TBD nVHz @ Rmr
= 45
TA detection & programmable
compensation
0.75ns Write rise/fall time (L=90 nH/40
mA)
Write current range = 15-60 mA (5-bits)
Programmable write current overshoot (4-
bits)
Programmable write current undershoot (3-
bit)
200ns Write/Read switching time
Servo write (half bank or all bank write)
Integrated Reader low freq. blocking
Capacitor
LD3511-XX
4, 6, up to 8-Channel
+5V, +8V GMR Head Preamplifier
Samples Available
Page 19 version 1.0
This document may contain preliminary information and is subject to change by LDIC without notice. LDIC assumes no responsibility or liability for any use of this information herein. Nothing in this document shall operate as an express or implied license of indemnity under the intellectual property rights of LDIC or third parties. NO WARRENTIES OF ANY KIND, INCLUDING, BUT NOT LIMITED TO, THE IMPLIES WARRENTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE OFFERED IN THIS DOCUMENT.
VDD
GND
VCC
MRRB
WDX WDY RBW
SCLK
SDEN
RDX RDY
SDATA
FLT
RGND
RREF
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
LD3511
4-channel
30-Pin
TSSOP
N/C W3X W3Y R3X MRGND R2X W2Y W2X W1X W1Y R1X MRGND R0X W0Y W0X
30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
Loading...