4.3.4 Properties
Select this sub-selection, the screen will show the properties of the file.
4.3.5 Cancel
Select this point to cancel any editing operations.
Advice:
The “Edit” button is only effective if the HDD is formated with the FAT32 file system.
5. Annex
5.1 FAQ
Before you contact our service department, please read the following guide.
Symptom Possible reasons Resolutions
No power Power cable not plugged in
Check if the DC power cable is
plugged in correctly
Power is on, but the unit does not
work properly
Restart the media player Disconnect the media player from
power, wait a few seconds and
restart the media player
No picture on the display/ TV/ PC
Media player not connected
properly
Connect the media player as
described in this manual
Video output does not comply
with the display equipment
Press the „HDMI/AV“ key on the
remote control
Display input is not set to receive
the player's signal
Select a proper video input
format, usually it is video or AV
No volume
Volume is set to 0 (TV or media
player)
Adjust the volume (Volume +)
Audio cable not connected
properly
Connect the audio cable correctly
Playing pictures glimmering or
having a bad quality
Reset and choose the correct TV
format such as NTSC or PAL
Restart the media player and
select the correct TV or display
format
Bad picture quality provided Take pictures with better quality
Battery status low Install new batteries, ensure
using the same size of batteries:
AAA, 1,5V
Battery not installed properly Install batteries correctly
Remote control does not point at
the remote sensor
Point the remote control at the
remote sensor
Too long distance or too big
angle
Keep a distance within 6m from
the front panel remote sensor;
lower angle to the sensor
The remote control does not work
Remote control route malfunction
Remove obstacles between the
player and the remote control
5.2 Copyright and trademark information
Copyrights