l-com HAKIT-72150-M01 Installation Manual
www.L-com.com
HAKIT-72150-M01 Installation Guide
Operational Overview
Step 1: The powerful outside antenna captures voice and
data signal and transfers it to the booster.
Step 2: The booster receives the signal, amplifies it and
rebroadcasts it by inside mounted antenna.
Step 3: Your mobile devices get a better signal, never
experience dropped calls or slow data speed.
Package Contents
Supported Carriers
• AT&T 2G/3G/4G (HSPA+ & LTE)
• Verizon 3G/4G
• T-Mobile 2G/3G/4G
• Sprint 3G/4G
• US Cellular 3G/4G
• Metro PCS 3G/4G
• Major Canadian Carriers 2G/3G/4G
• All other carriers using 700MHz, 850MHz, 1900MHz and
2100MHz
Booster Inside Antenna
IP-00139 Rev A 05/16/16
© L-com, Inc. All rights reserved. L-com Global Connectivity and the L-com logo are registered marks.
Outside Antenna Power Adapter
Step by step installation
www.L-com.com
Step 1: Mount the outside magnetic antenna
a. Choose right position
• 30cm (1.0ft) away from any other metallic objects
• 50cm (1.5ft) away from any windows
b. Mount the antenna: it must be mounted vertically on
top of the car.
Vertically mount
c. Set the outside antenna cable into the car
• Carefully pull down the door seal, run the cable into
the car under the seal
• Run the cable reach the location where you plan to
place the booster
• Push the seal back into place carefully
Step 2: mount the inside antenna
a. Choose right position
• 20cm (7.8in) away from any other metallic objects
• 50cm (1.5ft) away from any windows
• The position on the right hand of the drive’s seat is
recommended
b. Mount the inside antenna:
• Peel off the plastic on the back of the antenna
• Under it is the 3M sticker, place the antenna onto the
position selected
Step 3: arrange the booster
a. Choose position
• Under the assistant’s seat, or trunk of the car
• It is free from excessive heat, direct sunlight and
moisture
b. Connect the outside antenna’s connector to the
“outside” labeled port of the booster
Inside antenna Outside antenna
IP-00139 Rev A 05/16/16
© L-com, Inc. All rights reserved. L-com Global Connectivity and the L-com logo are registered marks.
Adapter cord
Step 4: power on the booster
a. Plug the power adapter to the car 12V DC lighter
b. Attach the cord of the adapter to the booster
c. Switch on the adapter by press the button of the
adapter, a blue light will be seen show it is working
Loading...