3
2
4
1
7
6
1.During cell conversation, press to mute, press again to
resume, at MUTE mode with RED light
2.Press once for last track, press and hold for volume
decreasing, to pick up the call
5
3.Press once for Play/Pause ,Press and hold 2 seconds
for SIRI function,When cell is coming in, press once
to pick up, and press again for shut down
4.Press once for next track, press and hold for volume
increasing, to pick up the call
5.Press and hold 2 seconds for power on/ off
6.MICRO USB:Need 5V 500MA for charging
7.Dame
8
8.LINE-IN; LINE-OUT: When insert earphone, will be mute
LED indicator:
MUTE mode with red LED light
Green : at AUX mode for green light, charging mode green light was sparking
Red : battery capacity lower than 3.5V red LED light was sparking
Blue : power on and during bluetooth pairing mode, blue LED indicator was sparking
And always for blue light when pairing sucessfully; charging mode is blue at bluetooth
mode, and always blue when charging full
At power off mode, it is green LED sparking during charging, and then always green
when full
Saving power,Power on and no bluetooth connection, will power off automatically after
10 minutes
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment. This equipment has been tested
and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions (1)this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation