LBL Lighting Zanz 3-Light User Manual

Page 1
Installation Instructions for
980ZANZ3W
Zanz 3-Light Bath
Wall
GP I :ENERAL RODUCT NFORMATION
This product is suitable for damp locations.
This product can mount either to a 4” square electrical box with a round plaster ring or an octagon electrical box.
This product can be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product requires installation by a qualified electrician. Before installing be sure to read all instructions and TURNTHE POWER TO THE ELECTRICAL BOX OFF.
BA7533_
1.0
Install the Mounting Plate
1A
2
1
MOUNTING STUD
TOP VIEW
2
SET SCREW
MOUNTING PLATE
2
1
1B
#8-32 SCREW
3
3
MOUNTING PLATE
1
Remove the two set screws located on bottom of the fixture base.
2
Remove the mounting plate by sliding it away from the mounting studs then out of the fixture.
3
Attach the mounting plate to the electrical box using the two #8-32 screws provided.
1
Page 2
Assemble the Fixture
2A
COLLARED NUT
SOCKET
1
Unscrew the collared nut and remove it from the socket.
2C
SPECIAL TOOL
GLASS SHADE
1
SOCKET
COLLARED NUT
2B
GLASS SHADE
SOCKET
3
1
Secure the glass shade by re-installing the collared nut on the socket and tighten it using the special tool.
4
Repeat section 2 for all the shades.
2
2
Install the glass shade by placing it on the socket.
2
Page 3
Install the Fixture
Install the Lamp
3A
2
1
3
1
Connect the fixture to a suitable ground in accordance with local electrical codes.
2
Connect the white fixture wire to the neutral power line wire with a wire nut.
3
Connect the black fixture wire to the hot power line wire with a wire nut.
4
Place all wires and wire nut connections in the electrical box and mount the fixture by sliding it back onto the mounting plate and reinstalling the two screws (reversal of figure 1A).
4A
LAMP
SOCKET
Use Volt, type T4, G9 baseMAX 60120 Watt bi-pin halogen lamp.
NOTE: Use only your fingers to replace the lamp.
1
Push the new lamp firmly all the way into the socket.
2
Repeat for all the sockets.
NOTE: To replace lamp, reverse section 4.
1
3
Page 4
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2013 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.
4
A Generation Brands Company
Loading...