LBL Lighting Vitre Square S User Manual
Installation Instructions for
980VITRESS
Vitre Suspension (Square)
Suspension
GP I :ENERAL RODUCT NFORMATION
This product is suitable for damp locations.
This product may be dimmed with a low-voltage electronic dimmer.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
SU831_
1.1
Install the Mounting Plate
1A
MOUNTING
PLATE
CANOPY
SCREW
CANOPY
1
Separate the mounting plate from the canopy by
removing the two canopy screws.
CANOPY
SCREW
1B
#8-32 SCREW
MOUNTING
PLATE
2
Secure the mounting plate to the electrical box with the
two #8-32 screws provided.
#8-32 SCREW
1
Assemble the Fixture
Adjust the Power Cord (optional)
2A
3
1
CABLE
CLUTCH
POWER
CORD
3A
1
Take note of the pre-wired connections and remove the
DRIVER WIRE
POWER CORD WIRE
wire nuts to disconnect the power cord wires from the
AIRCRAFT
CABLE
driver wires.
3B
4
NOTE: Make sure to support the fixture while
adjusting the aircraft cables. An assistant is
recommended to complete the remaining steps.
1
Feed the aircraft cables through the cable clutches in
the canopy.
2
Evenly pull the aircraft cable up through the canopy to
raise the fixture to the desired leveled length.
3
Cut off the excess aircraft cable leaving enough for fine
leveling later.
7
STRAIN RELIEF
SET SCREW
POWER
CORD
NOTE: The power cord does not support the fixture.
For a casual “lazy cord” look, cut the power cord
several inches longer that the drop height of the
fixture.
2
Loosen the set screw in the strain relief.
3
Pull the power cord through the canopy until it reaches
the length desired and re-tighten the set screw.
4
Leave 6 inches of cord behind the canopy and cut off
extra cord.
2
Loading...