LBL Lighting Vision Chandelier User Manual
Installation Instructions for
980MRLVISNCH
Visions Chandelier Head
Monorail
GENERAL PRODUCT INFORMATION:
This product is ETL listed and suitable only for indoor dry locations
and approved for use at any height above the finished floor.
This product is intended to be used with LBL Monorail system.
Install the Lamp and Disk
HA336_1A35MRL
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1.3
1A1A
SOCKET
LAMP
NOTE: To reduce the risk of a burn or electric shock
during relamping, disconnect the power to the fixture.
Use MAX 35 Watt MR11 Front Cover Halogen
Lamp .
1
1A1B
CURVED
SECTION
CRYSTAL
GLASS DISK
ACCESSORY
SPRINGS
2
2
2
CURVED
SECTION
2
1
Align and push the lamp pins completely into the socket holes.
2
Orient the recessed section of the crystal glass disk towards
the lamp. Place edge of the crystal disk into curved section of
accessory springs.
NOTE: The Crystal disk must be removed when relamping.
1
Install the Fixture to Monorail
1A2A
3
2
1
Unscrew the cap from the Fusion Jack adapter.
2
Select a place on the Monorail where the fixture is going to be
FUSION JACK
ADAPTER
CAP
mounted.
3
From the top or bottom, place the Fusion Jack adapter onto
the Monorail.
Replace and tighten the cap to the Fusion Jack adapter. Make
4
sure that the cap is not cross threaded.
1A2B
2B
SAVE THESE INSTRUCTIONS!
FIXTURE
FUSION JACK
ADAPTER
5
Push and screw the fixture Fusion Jack completely into the
5
FUSION JACK
Fusion Jack adapter.
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting. All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands CompanyA Generation Brands Company
2
Loading...