LBL Lighting Vera Flush Mount LED User Manual

Installation Instructions for
980VERACD
Vera Ceiling (LED)
Ceiling
GP I :ENERAL RODUCT NFORMATION
This product can mount to either a 4” square electrical box with a round plaster ring or an octagon electrical box.
This product is suitable for damp locations.
This product may be dimmed with a low-voltage electronic dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
FM779_LED
1.0
Install the Mounting Plate
1A
FIXTURE
2
1
Remove the four mounting rods and separate the shade from the fixture.
MOUNTING ROD
SHADE
1B
THREADED
STUD
2
FIXTURE
2
Remove the mounting plate from the fixture by unscrewing the two cap nuts from the two threaded studs.
MOUNTING PLATE
CAP NUT
1
1C
MOUNTING PLATE
ELECTRICAL BOX
2B
MOUNTING PLATE
FIXTURE
3
#8-32 SCREW
3
Mount the mounting plate to the electrical box with
#8-32 SCREW
the two #8-32 screws.
Install the Fixture
2A
1
2
3
5
CAP NUT
3
24
Properly place all wires and wire nut connections into
5
STUD
the fixture.
25
Mount the fixture onto the threaded studs on the mounting plate and secure it by tightening the two cap nuts.
2C
FIXTURE
MOUNTING ROD
FIXTURE
1
Connect the mounting plate ground wire to a suitable ground in accordance with local electrical codes.
2
Connect the white driver wire to the neutral power line wire with a wire nut.
3
Connect the black driver wire to the hot power line wire with a wire nut.
SHADE
2
6
Align the shade with the fixture and install the four mounting rods by screwing them in completely.
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.
2
A Generation Brands Company
Loading...