LBL Lighting Vera Flush Mount CF User Manual
Installation Instructions for
980VERACCF
Vera Ceiling (Compact Fluorescent)
Ceiling
GP I :ENERAL RODUCT NFORMATION
This product can mount to either a 4” square electrical box with a
round plaster ring or an octagon electrical box.
This product is suitable for damp locations.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
FM779_CF_
1.0
Install the Mounting Plate
1A
FIXTURE
2
1
Remove the four mounting rods and separate the shade
from the fixture.
MOUNTING ROD
SHADE
1B
THREADED
STUD
2
FIXTURE
2
Remove the mounting plate from the fixture by
unscrewing the two cap nuts from the two threaded
studs.
MOUNTING
PLATE
CAP NUT
1
1C
MOUNTING
PLATE
ELECTRICAL BOX
2B
MOUNTING PLATE
FIXTURE
3
#8-32 SCREW
3
Mount the mounting plate to the electrical box with
#8-32 SCREW
the two #8-32 screws.
Install the Fixture
2A
1
2
3
5
CAP NUT
3
24
Properly place all wires and wire nut connections into
5
STUD
the electrical box.
25
Mount the fixture onto the threaded studs on the
mounting plate and secure it by tightening the two
cap nuts.
FIXTURE
1
Connect the mounting plate ground wire to a suitable
ground in accordance with local electrical codes.
2
Connect the white ballast wire to the neutral power line
wire with a wire nut.
3
Connect the black ballast wire to the hot power line
wire with a wire nut.
2
Loading...