Installation Instructions for
980VERAC
Vera Ceiling
Ceiling
GP I :ENERAL RODUCT NFORMATION
This product can mount to either a 4” square electrical box with a
round plaster ring or an octagon electrical box.
This product is suitable for damp locations.
This product can be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
FM779_2D
1.0
Install the Mounting Plate
1A
FIXTURE
2
1
Remove the four mounting rods and separate the shade
from the fixture.
MOUNTING ROD
SHADE
1B
THREADED
STUD
2
FIXTURE
2
Remove the mounting plate from the fixture by
unscrewing the two cap nuts from the two threaded
studs.
MOUNTING
PLATE
CAP NUT
1
1C
MOUNTING
PLATE
ELECTRICAL BOX
2B
MOUNTING PLATE
FIXTURE
3
#8-32 SCREW
3
Mount the mounting plate to the electrical box with
#8-32 SCREW
the two #8-32 screws.
Install the Fixture
2A
1
2
3
5
CAP NUT
3
24
Properly place all wires and wire nut connections into
5
STUD
the electrical box.
25
Mount the fixture onto the threaded studs on the
mounting plate and secure it by tightening the two
cap nuts.
FIXTURE
1
Connect the mounting plate ground wire to a suitable
ground in accordance with local electrical codes.
2
Connect the white fixture wire to the neutral power line
wire with a wire nut.
3
Connect the black fixture wire to the hot power line
wire with a wire nut.
2
Install the Lamps
Install the Shade
3A
LAMP
CAUTION: To reduce the risk of a burn or electric
shock during relamping, disconnect the power to
the fixture.
SOCKET
4A
FIXTURE
2
1
Align the shade with the fixture and install the four
mounting rods by screwing them in completely.
MOUNTING ROD
SHADE
NOTE: To re-lamp, reverse the section 4 instructions
to remove the shade and gain access to the lamps
and sockets.
Use 120 voltMAX 75 Watt
Type A19 Medium Base Lamp.
21
Screw the lamps into the sockets.
3
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
4
A Generation Brands Company
Loading...