LBL Lighting Twin Spot Swivel User Manual
Installation Instructions for
980FSJTWNSPS
Twin Spot Swivel
Fusion Jack™
GENERAL PRODUCT INFORMATION:
This product is ETL listed and suitable only for indoor dry locations
and approved for use at any height above the finished floor.
Colored and Dichroic lenses, and Diffuser, Linear Spread, or
Structure louvers are the compatible accessories.
WARNING: Risk of Fire. Hot Surface. Install the fixture
at least 6" (Inches) away from wall, curtains and combustible
materials. Maintain at least 9" (Inches) of clearance directly in
front of the fixture.
AVERTISSEMENT: Risque du feu. Surface Chaude.
Installez le montage au moins 6" (Pouces), 153 mm, loin du
mur, des rideaux et des matériaux combustibles. Maintenez au
moins 9" (Pouces), 230 mm, de dégagement directement
devant le montage.
HE382_1A35FSJ
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1.2
Install the Lamp
1A 1B
SOCKET
LAMP
1
2
NOTE: To reduce the risk of a burn or electric shock
during relamping, disconnect the power to the fixture.
Use MAX 35 Watt MR16 Front Cover
Halogen Lamp With Each Head.
3
OPTIONAL ACCESSORY
3
CAP
Place the optional accessory into the cap, and tighten the cap
to the fixture head.
FIXTURE HEAD
1
For each head, align the lamp pins with socket holes.
Push the lamp pins completely into the socket holes.
2
1
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting. All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
2
A Generation Brands Company
Loading...