LBL Lighting Tube 2 P User Manual
Installation Instructions for
980MRLTUB2P
Tube 2
Monorail
GP I :ENERAL RODUCT NFORMATION
This product is ETL listed and suitable only for indoor dry locations
and approved for use at any height above the finished floor.
This product is intended to be used with LBL Monorail system.
Connect the Fixture Arms
HS2932FR_1B35MRL
1.2
1A1A
(H)
(H1)
FIXTURE
FUSION
JACK
1A1B
(L)
3 2
FIXTURE ROD
2
Mark amount (LI) from one end of the fixture rod that needs
to be cut shorter. (Optional)
NOTE:To avoid interference while relamping do not
cut the fixture rods (LI) more than 24" inches.
3
Cut the fixture arms with a sharp cutter. (Optional)
1A1C
4
M3 SET
SCREW
4
1.6 MM
ALLEN
WRENCH
GLASS SHADE
1
The overall fixture height (H) is measured from bottom of the
bottom glass shade to the end of the fixture Fusion Jack.
Determine the overall desired fixture height.The height (H1) is
from the bottom of the top shade to the end of the fixture
Fusion Jack and it is 39" inches when the fixture rods are
not cut.
SOCKET PIN HOLE
4
Loosen the two M3 set screws on the(Do Not Remove)
socket assembly rods that are located on the opposite side of
socket pin holes.
1
1A1D
FIXTURE ROD
1A1G
FIXTURE
FUSION
JACK
5 5
1.5 MM ALLEN
WRENCH
SOCKET
PINHOLE
5
Insert the two fixture rods on the opposite side of socket pin
M3 SET
SCREW
SOCKET
ASSEMBLY
ROD
holes, completely into the socket assembly rod and secure into
place by tightening the M3 set screws with the provided
1.5 MM Allen wrench.
1A1E
1.5 MM ALLEN
WRENCH
FUSION JACK
M3 SET SCREW
6
6
Loosen the two M3 set screws on the(Do Not Remove)
ASSEMBLY ROD
6
sides of the Fusion Jack assembly rod with the provided
1.5 MM Allen Wrench.
1A1F
M3 SET SCREW
TOP SOCKET
ASSEMBLY ROD
(H2)
8
The height (H2) is measured from bottom of the bottom glass
8
GLASS SHADE
shade to the middle of the top socket assembly rods.
Determine the desired (H2) fixture height.The height (H2) is
39" inches when the fixture rods are not cut.
1A1H
FIXTURE ROD
10 9
(L2)
7
7
1.5 MM ALLEN
WRENCH
FUSION
JACK
ASSEMBLY
ROD
FIXTURE ROD
7
Insert the fixture rods into the Fusion Jack assembly rod,make
sure the fixture rods are aligned with the top of the Fusion
Jack assembly rod.Tighten the two M3 set screw with 1.5 MM
Allen wrench.
9
10
10
1A1I
11
2
Mark amount (L2) from one end of the fixture rod that needs
to be cut shorter. (Optional)
NOTE:To avoid interference while relamping do not
cut the fixture rods (L2) more than 24" inches.
Cut the fixture arms with a sharp cutter. (Optional)
FUSION JACK
ASSEMBLY ROD
M3 SET SCREW
11
FIXTURE ROD
1.5 MM ALLEN
WRENCH
Insert the fixture rods into the top Fusion Jack assembly rods,
and tighten the two M3 set screw with 1.5 MM Allen wrench.
Loading...