LBL Lighting Tube 1 P User Manual
Installation Instructions for
980MRLTUB1P
Tube 1
Monorail
GP I :ENERAL RODUCT NFORMATION
This product is ETL listed and suitable only for indoor dry locations
and approved for use at any height above the finished floor.
This product is intended to be used with LBL Monorail system.
Connect the Fixture Arm
HS2931FR_1B35MRL
1.2
1A1A
(H)
FIXTURE
FUSION
JACK
1A1B
(L)
3 2
FIXTURE ROD
2
Mark amount (L) from one end of the fixture rod that needs to
be cut shorter. (Optional)
NOTE:To avoid interference while relamping do not
cut the fixture rods (L) more than 24" inches.
3
Cut the fixture arms with a sharp cutter. (Optional)
1A1C
4
M3 SET
SCREW
4
1.6 MM
ALLEN
WRENCH
GLASS SHADE
1
The overall fixture height (H) is measured from bottom of the
glass shade to the end of the fixture Fusion Jack. Determine
the overall desired fixture height.The overall fixture height (H)
is 39" inches when the fixture rods are not cut.
SOCKET PIN HOLE
Loosen the two M3 set screws on the(Do Not Remove)
4
socket assembly rods that are located on the opposite side of
socket pin holes.
1
1A1D
1A1F
M3 SET SCREW
FIXTURE ROD
5 5
1.5 MM ALLEN
WRENCH
5
Insert the two fixture rods completely into the socket
M3 SET
SCREW
SOCKET
ASSEMBLY
ROD
assembly rods and secure them place by tightening the M3 set
screws with the provided 1.5 MMAllen wrench.
1A1E
1.5 MM ALLEN
WRENCH
FUSION JACK
ASSEMBLY ROD
M3 SET SCREW
7
7
1.5 MM ALLEN
WRENCH
FUSION
JACK
ASSEMBLY
ROD
FIXTURE ROD
6
6
Loosen the two M3 set screws on the(Do Not Remove)
sides of the Fusion Jack assembly rod with the provided
1.5 MM Allen wrench.
6
7
Insert the fixture rods into the Fusion Jack assembly rod,make
sure the fixture rods are aligned with the top of the Fusion
Jack assembly rod.Tighten the two M3 set screw with 1.5 MM
Allen wrench.
2
Loading...