LBL Lighting Top-SI Coax User Manual
Installation Instructions for
980FSJTOPSICP
Top-SI Coax
Fusion Jack™
GENERAL PRODUCT INFORMATION:
This product is ETL listed and suitable only for indoor dry locations
and approved for use at any height above the finished floor.
CAUTION - RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURN THE POWER TO THE
ELECTRICAL BOX OFF.
Install the Lamp
HS240_1B50FSJ
1.4
1A
THUMB SCREW
SOCKET
LAMP
1
Remove the three thumb screws.
NOTE: To reduce the risk of a burn or electric shock
during relamping, disconnect the power to the fixture.
NOTE: Use only your fingers and soft cloth to replace
the lamp.
1B
1
1
1
3
2
3
Carefully slide the diffuser glass completely onto the socket,
align the diffuser glass hole with the socket #4-40 set screw.
4
Slightly back out the #4-40 set screw with the 0.05 Allen
wrench to hold the diffuser glass in place.
SOCKET
4
0.05 ALLEN
WRENCH
#4-40 SET
SCREW
DIFFUSER GLASS
Use MAX 50 Watt, Type Xelogen
(Xenon) Bi-Pin Lamp.
2
Push the lamp pins completely into the socket holes.
WARNING: RISK OF FIRE
Never replace a Xenon (Xelogen) lamp with a regular
Halogen lamp. A regular Halogen lamp requires a
protective glass shield.
1
1C
2B
5
THUMB SCREW
5
5
Align the glass shade holes with the bracket holes. Replace and
BRACKET
5
GLASS SHADE
tighten the three thumb screws to secure the glass shade in
place. Adjust the thumb screws if the glass is not level.
ALLEN WRENCH
SET SCREW
2
3
2
Back out (do not remove) the set screw on the conical
connector with the provided Allen wrench.
3
Pull the coaxial cable out.
2C
5
Adjust the Fixture Height
2A
ALLEN WRENCH
SET SCREW
1
Back out (do not remove) the set screw on tip of the
connector with the provided Allen wrench.
4
Cut the coaxial cable to the desired length.
5
Gently twist the end of the coaxial cable between thumb and
forefinger.
2D
SURFACE
1
6
Tap the conical connector on a hard surface with the set screw
facing down, so the plate inside drops into place.
PLATE
2
Loading...