Installation Instructions for
980MRLTGRID
T-Grid Clip
Monorail
GP I :ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
Install the T-Grid Clip
1A1A
CLIP-TB/MONO-_
Install the Rigid Standoff
1A2A
SUPPORT POST
1
1.1
2
GRID
1
Select the locations on the grids where the standoffs will be
mounted.
2
Push the T-Grid clip flat section against the grid. Rotate the
T-Grid clip until the tabs on the T-Grid clip snap behind
the grid.
TAB
1A1B
THREADED NIPPLE
3
Screw the threaded nipple to the threaded stud.
3
THREADED STUD
M4 SET
SCREW
1
Loosen the M4 set screw on the support(Do Not Remove)
post with the 2 MM Allen wrench provided to remove the
support post.
2 MM ALLEN
WRENCH
1A2B
THREADED NIPPLE
2
Screw the support post completely to the threaded nipple.
2
SUPPORT POST
1
Install the Adjustable Cable Standoff
1A2C
SUPPORT POST
3
STANDOFF ROD
3
Push the standoff rod completely into the support post and
tighten the M4 set screw with the 2 MM Allen wrench.
4
Refer to the instruction provided with the standoff to
complete the installation.
M4 SET SCREW
2 MM ALLEN
WRENCH
1A3A
CABLE POST
1
Screw the cable post completely to the threaded nipple.
Refer to the instruction provided with the standoff to
2
complete the instruction.
1
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
2
A Generation Brands CompanyA Generation Brands Company