LBL Lighting Tear-SII Coax P User Manual

Installation Instructions for
Tear-S II
Fusion Jack
GP I :ENERAL RODUCT NFORMATION
This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor.
980FSJTRSIIP
HS235_
HS252_
1.3
1.2
This product requires installation by a qualified
CAUTION - RISK OF FIRE
electrician. Before installing be sure to read all instructions and TURNTHE POWER TO THE ELECTRICAL BOX OFF.
Adjust the Fixture Height
1A
FIXTURE COAXIAL CABLE
GLASS SHADE
1B
ALLEN WRENCH
SET SCREW
CONNECTOR
Back out (do not remove) the set screw on tip of the connector with the provided Allen wrench.
1C
SOCKET ASSEMBLY
Feed the fixture coaxial cable through the glass shade. Slide the glass shade down the cord and rest it onto the socket assembly.
Cut the coaxial cable to the desired length.
ALLEN WRENCH
SET SCREW
Back out (do not remove) the set screw on the conical connector with the provided Allen wrench.
1
1D
Gently twist the end of the coaxial cable between thumb and forefinger.
1E
SURFACE
PLATE
Tap the conical connector on a hard surface with the set screw facing down, so the plate inside drops into place.
1G
ALLEN WRENCH
Look into the sight hole on the top of the connector to make
INNER WIRE
SIGHT HOLE
10
sure that the inner wire is contacting the end of the connector.
10
Hold the coaxial cable in place and tighten the set screw on tip of the connector with the provided Allen wrench. Make sure this set screw connection is tight.
1H
11
1F
CONICAL CONNECTOR
Feed and push the coaxial cable into the conical connector.The coaxial cable will come to a stop point after being inserted 3/4" into the conical connector.
1G
WRINKLE ON OUTER WRAPPED WIRE
Keep pushing the coaxial cable into the connector while rotating the connector to ease feeding the inner wire into the tip of the connector.The outer wrapped wire will start wrinkling while being inserted another 1/2" into the connector.
OUTER WRAPPED WIRE STOPS HERE
INNER WIRE STOPS HERE
11
Firmly tighten the set screw on the conical connector.
1I
12
12
Pull the coaxial cable toward the fixture to smooth the wrinkles.
2
Loading...
+ 2 hidden pages