LBL Lighting Suspension canopy User Manual

Installation Instructions for
980CK001L
Suspension Canopy
Suspension
GENERAL PRODUCT INFORMATION:
This product can be dimmed with a standard incandescent dimmer.
Install the Canopy
1A
1C
CK001L_
1
1.1
CANOPY
CROSSBAR ASSEMBLY
Turn the power to the electrical box off.
1
Make sure that the crossbar assembly is grounded in
2
accordance with local electrical codes.
Mount the crossbar assembly to the electrical box with the
3
two provided #8-32 screws.
3
2
3
#8-32 SCREW
1B
4
PLASTIC SET SCREW
Loosen (Do Not Remove) the plastic set screw on the strain
4
relief.
STRAIN RELIEF
5
5
Feed the cord through the strain relief and the canopy.
5
1D
7
8
Adjust the fixture height (from bottom of the fixture shade to
6
top of the canopy) by moving the canopy up or down.
7
When the desired height is achieved, tighten the plastic set screw on the strain relief.
Mark the cord underneath of the strain relief.
8
STRAIN RELIEF
CORD
CANOPY
CORD
1
1E
1G
9
11
4"
10
Leave 6" of the cord behind the canopy for power connections.
9
Cut the excess cord.
From the end of the cord, strip the insulation 4" using a sharp
10
knife. Make sure not to nick the inner wires.
Strip the end of the wires.
11
1F
13
12
PLASTIC SET SCREW
18
19
STRAIN RELIEF
CORD
NOTE: It is recommended that one person hold the
fixture while the electrician finishes the installation.
Align the canopy center hole with the crossbar center hole.
17
Slide the canopy up against the ceiling and secure it in place by
18
tightening the strain relief into the crossbar. Do not turn the
cord.
Push the cord into the canopy and line up the marked point on
19
the cord with bottom of the strain relief. Tighten the plastic set screw to secure the fixture in place.
14
16
Feed the fixture wires through the crossbar center hole an
12
14
then bring them out of the electrical box.
Connect the fixture ground wire to the ground in accordance
13
with local electrical codes.
Connect the other fixture wires properly to power line wires
14
with wire nuts.
Place all wires and wire nut connections properly inside the
15
electrical box.
16
Loosen (Do not remove) the plastic set screw on strain relief so that it can slide.
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2008 LBL Lighting. All rights reserved. The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.
A Generation Brands Company
2
Loading...