LBL Lighting Sophia User Manual

Installation Instructions for
980SOPHIW
Sophia Wall
Wall
GP I :ENERAL RODUCT NFORMATION
This product is suitable for damp locations.
This product can be dimmed with a standard incandescent dimmer.
CAUTION - RISK OF FIRE
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
HW266_SC2G60
1.5
Install the Fixture
1A 1B
BACKPLATE
M3 SET SCREW
2
1
CANOPY
1
Loosen the two M3 set screws on side of(Do Not Remove) the canopy with the 1.6MM Allen wrench provided.
Remove the backplate.
2
1.6MM ALLEN WRENCH
3
4
#8-32 SCREW
3
4
BACKPLATE
Line up two backplate holes with the electrical box holes.
Mount the backplate to the electrical box with the two #8-32 screws provided.
4
ELECTRICAL BOX HOLE
1
Install the Lamp
1C
7
6
5
In accordance with local electrical codes, make sure that the backplate is grounded.
6
Connect the fixture white wire to the neutral power line wire with a wire nut.
7
Connect the fixture black wire to the hot power line wire with a wire nut.
2A
LAMP
1
SOCKET
NOTE:Use only your fingers and a soft cloth to install
the lamp.
Use 120 Volt, WattTypeT4,MAX 40 G9 Base, Bi-Pin Halogen Lamp.
1
Push the lamp pins completely into the socket holes.
1D
M3 SET SCREW
9
1.5MM ALLEN WRENCH
CANOPY
8
Place all wires and wire nut connections properly inside the electrical box.
9
Place the fixture canopy onto the backplate. Level the fixture vertically and tighten the two M3 set screws with the 1.5MM Allen wrench to secure the fixture in place.
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.
A Generation Brands Company
2
Loading...