LBL Lighting Rock Candy 8-Light Chandelier CH User Manual

Installation Instructions for

Rock Candy 5 and 8 Light Suspension

SUSPENSION

GP I :ENERAL RODUCT NFORMATION

This product is suitable for damp locations.

This product can mount either to a 4” square electrical box with a
round plaster ring or an octagon electrical box.

This product can be dimmed with a standard incandescent dimmer.

This instruction shows a typical instruction.

980ROCKCCH

SU6235_
SU6238_

1.0

This product requires installation by a qualified

CAUTION - RISK OF FIRE

electrician. Before installing be sure to read all
instructions and TURNTHE POWER TO THE
ELECTRICAL BOX OFF.

CAUTION: Due to the fixture’s weight,

assistance will be needed for installation.

Install Lamps and Shades

1A

1B

LAMP

SOCKET

INNER
GLASS
SHADE

SOCKET
ASSEMBLY
BASE

CAUTION: To reduce the risk of a burn or electric

shock during relamping, disconnect the power to
the fixture.

Use Volt, type T4, G9 baseMAX 60120 Watt
bi-pin halogen lamp in each socket.

NOTE: Use only your fingers and a soft cloth to

replace the lamp.

1

Push the lamp base completely into the socket.

2

Gently push the inner glass shade into the center of the
socket assembly base until it is firmly in place.

NOTE: Opal version does not have an inner
glass.

1

IMPORTANT SAFETY INSTRUCTIONS

1C

SOCKET
ASSEMBLY
BASE

OUTER
GLASS
SHADE

To reduce the risk of fire, electrical shock, exposure to

excessive UV radiation, or injury to person:

– Use this fixture indoors only.

– Do not look directly at the lighted lamp.

– Do not remain in light if skin feels warm.

– Risk of fire: Use only the type of lamp and maximum wattage

indicated in this instruction manual.

– Never cover the halogen lamp with anything other than a LBL

Lighting lamp shield and never place flammable material close to
your fixture.

– Never turn the fixture on and off by connecting and

disconnecting the halogen lamp.

– Do not touch the fixture shades or lamp shield while the fixture

is on.These surfaces may be HOT.

Halogen Lamp General Information

– A new halogen lamp may smoke slightly when it is used for the

first time.This is perfectly normal; the protective coating is simply
being vaporized.

3

Carefully screw the outer glass shade onto the socket
assembly base until it is firmly in place.

NOTE:To re-lamp, reverse the section 1 instructions.

TwoTips For Prolonging Halogen
Lamp Life

– First avoid touching the lamp with bare hands during installation.

Any contaminant, even the oil from your hands can deteriorate
the lamp. Rubbing alcohol can be used to remove any
contaminant.

– Second, do not run the lamps at full power when you do not need

to. However, if dimming the fixture for an extended period of
time, occasionally bring the light up to full brightness for a few
minutes to complete the halogen cycle.

SAVE THESE INSTRUCTIONS!

7400 Linder Ave, Skokie, IL 60077

800.323.3226 - 847.626.6300

www.lbllighting.com

© 2013 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.

2

A Generation Brands Company