LBL Lighting Rev Swivel User Manual
Installation Instructions for
980FSJREVS
Rev Swivel
Fusion Jack™
GP I :ENERAL RODUCT NFORMATION
This product is ETL listed and suitable only for indoor dry locations
and approved for use at any height above the finished floor.
WARNING: Risk of Fire. Hot Surface. Install the fixture
at least 6" (Inches) away from wall, curtains and combustible
materials. Maintain at least 9" (Inches) of clearance directly in
front of the fixture.
AVERTISSEMENT:Risque du feu. Surface Chaude.
Installez le montage au moins 6" (Pouces), 153 mm, loin du
mur, des rideaux et des matériaux combustibles. Maintenez au
moins 9" (Pouces), 230 mm, de dégagement directement
devant le montage.
Install the Lamp
HE441_1A50FSJ
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1.5
1A
1
Pull the cap out of socket housing.
SOCKET HOUSING
CAP
1B
SPRING END
2
Squeeze the spring ends and remove it from the cap.
1C
SPRING END
Use Watt MR16 Front CoverMAX 50
Halogen Lamp.
3
Place the MR16 lamp into the cap.
4
Squeeze the spring ends and place it into the groove inside the
cap to hold the MR16 lamp in place.
4
5
3
CAP
CAP
5
Release the spring ends.
1
1D
SOCKET
LAMP
REFLECTOR
NOTE:To reduce the risk of a burn or electric shock
during relamping, disconnect the power to the fixture.
6
Push the lamp pins completely into the socket holes.
1E
SOCKET HOUSING
7
CAP
Push the cap along with the reflector and MR16 lamp
7
completely into the socket housing
To install the fixture, refer to the instructions provided with
8
the system.
2
Loading...