LBL Lighting Rania W LED User Manual
Installation Instructions for
980RANIAWD
Rania Bath (LED)
Wall
GP I :ENERAL RODUCT NFORMATION
This product is suitable for damp locations.
This product can mount either to a 4” square electrical box with a
round plaster ring or an octagon electrical box.
May be dimmed with a low-voltage electronic dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
BA823_LED
1.0
Install the Mounting Plate
1A
BRACKET
BRACKET
1
1
SCREW
1B
MOUNTING PLATE
FIXTURE SCREW
FIXTURE SCREW
3
3
1
Remove the bracket screws located on the top and
bottom of the fixture base.
2
Remove the brackets from the fixture base.
3
Remove the fixture screws located on the top and
bottom of the fixture base.
4
Remove the mounting plate from the fixture base.
1
Install the Shade
1C
#8-32 SCREW
5
5
MOUNTING
PLATE
5
Attach the mounting plate to the electrical box using
the two #8-32 screws provided.
Install the Fixture
2A
FIXTURE BASE
3A
1
UPPER
BRACKET
2
THREAD
CAUTION: Do not release glass until both brackets
have been fully secured, the glass may fall and break
resulting in injury.
3
1
BRACKET SCREW
BRACKET SCREW
SHADE
LOWER
BRACKET
3
DRIVER
2
1
Connect the mounting plate ground wire to a suitable
ground according to local electrical codes.
2
Connect the brown (black) driver wire to the hot power
line wire with a wire nut.
3
Connect the blue (white) driver wire to the neutral
power line wire with a wire nut.
1
Reinstall the lower bracket and secure it in place using a
bracket screw.
2
Carefully lower the glass shade onto the lower bracket’s
threads and hold in place.
3
Reinstall the upper bracket and secure it in place using a
1
bracket screw.
1
SAVETHESE INSTRUCTIONS!
4
Properly place the driver, all wires, and wire nut
connections into the fixture base.
5
Mount the fixture by sliding it back onto the mounting
plate and reinstalling the fixture screws (reversal of
figure 1B).
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
2
A Generation Brands Company
Loading...