LBL Lighting Rania W User Manual
Installation Instructions for
980RANIAW
Rania Bath (Fluorescent)
Wall
GP I :ENERAL RODUCT NFORMATION
This product is suitable for damp locations.
This product can mount either to a 4” square electrical box with a
round plaster ring or an octagon electrical box.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
BA823_
1.0
Install the Mounting Plate
1A
BRACKET
BRACKET
1
1
SCREW
1B
MOUNTING PLATE
FIXTURE SCREW
FIXTURE SCREW
3
3
1
Remove the bracket screws located on the top and
bottom of the fixture base.
2
Remove the brackets from the fixture base.
3
Remove the fixture screws located on the top and
bottom of the fixture base.
4
Remove the mounting plate from the fixture base.
1
Install the Lamp
1C
#8-32 SCREW
5
5
MOUNTING
PLATE
5
Attach the mounting plate to the electrical box using
the two #8-32 screws provided.
Install the Fixture
2A
FIXTURE BASE
3A
SOCKET SOCKET
1
SOCKET
CAUTION: To reduce the risk of a burn or electric
shock during relamping, disconnect the power to
the fixture by turning the wall switch off.
LAMP
2
LAMP
Use type T5 High OutputMAX 24 Watt
linear fluorescent lamp.
3
1
BALLAST
2
1
Connect the mounting plate ground wire to a suitable
ground according to local electrical codes.
2
Connect the black ballast wire to the hot power line
wire with a wire nut.
3
Connect the white ballast wire to the neutral power line
wire with a wire nut.
1
Align the lamp pins with socket slots.
2
Push the pins all the way into the socket slots and rotate
the lamp until it clicks into place.
4
Properly place the ballast, all wires, and wire nut
connections into the fixture base.
5
Mount the fixture by sliding it back onto the mounting
plate and reinstalling the fixture screws (reversal of
figure 1B).
2
Loading...