Installation Instructions for
980FSJPUCS
Puck Swivel
Fusion Jack™
GP I :ENERAL RODUCT NFORMATION
This product is ETL listed and suitable only for indoor dry locations
and approved for use at any height above the finished floor.
WARNING: Risk of Fire. Hot Surface. Install the fixture
at least 6" (Inches) away from wall, curtains and combustible
materials. Maintain at least 9" (Inches) of clearance directly in
front of the fixture.
AVERTISSEMENT: Risque du feu. Surface Chaude.
Installez le montage au moins 6" (Pouces), 153 mm, loin du
mur, des rideaux et des matériaux combustibles. Maintenez au
moins 9" (Pouces), 230 mm, de dégagement directement
devant le montage.
HE437SC_1A50FSJ
1.6
Install the Lamp
1A
2
SPRING END
NOTE:To reduce the risk of a burn or electric shock
during relamping, disconnect the power to the fixture.
Use 50 Watt,AR111 (PAR36) HalogenMAX
Lamp.
LAMP
3
CAP
1
1B
5
4
Loosen the #8-32 screws on the lamp(Do Not Remove)
bracket.
FIXTURE
BRACKET
#8/32 SCREW
4 4
1
Place the AR111 lamp into the cap.
2
Squeeze the spring ends and place it into the groove inside the
cap to hold the AR111 lamp in place.
3
Release the spring ends.
5
Slide the fixture bracket slots under the #8-32 screws.
1
1C
6 6
6
Tighten the #8-32 screws to secure the lamp in place and
ensure power connection. Make sure that the screw
connections are very tight to avoid heat build up and
corrosion.
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
2
A Generation Brands Company