Installation Instructions for
980PRESIWCF8
Presidio 2x18W Compact Fluorescent
Wall
GP I :ENERAL RODUCT NFORMATION
This product can mount to either a 4" square electrical box with
round plaster ring or an octagon electrical box.
This product is suitable for damp locations.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
PW614_218_HE
1.2
Install the Fixture
1A 1B
#8-32 SCREW
1
CROSSBAR
ASSEMBLY
1
Mount the crossbar assembly to the electrical box holes with
the two #8-32 screws provided.
1
ELECTRICAL BOX HOLE
2
MOUNTING PLATE
3
2
4
In accordance with local electrical codes, make sure that the
crossbar assembly is grounded.
3
Connect the fixture white wire to the neutral power line wire
with a wire nut.
4
Connect the fixture black wire to the hot power line wire with
a wire nut.
1
Install the Lamp & Shade
1C
LOCK
WASHER
6
NUT
7
5
Place all wires and wire nut connections properly inside the
electrical box.
Level the mounting plate vertically and slide the center hole
6
completely onto the exposed threaded nipple.
7
Secure the mounting plate to the threaded nipple with lock
washer and nut.
THREADED
NIPPLE
MOUNTING
PLATE
2A
SOCKET
1
LAMP
LAMP PIN
1
Use WattType QuadTubeMAX 18
G24q-2 Base Compact Fluorescent
Lamp With Each Socket.
1
Install each lamp by pushing the lamp pins completely into the
socket holes.
2