LBL Lighting Palm Lane Large User Manual
Installation Instructions for
980PALMLNLO
Palm Lane Large Outdoor
Outdoor
GENERAL PRODUCT INFORMATION:
This product is suitable for wet locations.
This product can mount either to a 4” square electrical box with a
round plaster ring or an octagon electrical box
This product can be dimmed with a standard incandescent dimmer.
CAUTION - RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURNTHE POWER TO THE
ELECTRICAL BOX OFF.
JW637_2D
1.0
Install the Mounting Plate
1A 1B
ALLEN WRENCH
1
1
SET SCREW
MOUNTING
PLATE
1 1
#8-32 SCREW
3
3
MOUNTING
PLATE
1
With the Allen wrench provided, back out (do not fully
remove) the four set screws.
Remove the mounting plate from the back of the
2
fixture.
Attach the mounting plate to the electrical box using
3
the two #8-32 screws provided.
1
Assemble the Fixture
2A
1
GLASS SHADE
COLLARED NUT
1
Rest the fixture upside down and slide the glass shade
onto the fixture base.
1
2
SOCKET ASSEMBLY
2C
7
For wet locations, caulk around the base with
waterproof construction sealant.
2
Secure the glass shade by installing and tightening the
collared nut onto the socket assembly.
2B
4
5
1
3
Connect the mounting plate ground wire to a suitable
ground according to local electrical codes.
3
4
Connect the white fixture wire to the neutral power line
wire with a wire nut.
5
Connect the black fixture wire to the hot power line
wire with a wire nut.
6
Properly place all the wire and wire nut connections into
the fixture and mount it by reversing figure 1A.
2
Loading...