LBL Lighting Onyx Teardrop Chandelier User Manual
Installation Instructions for
980MRLONYXCH
Onyx Chandelier Head
Monorail
GP I :ENERAL RODUCT NFORMATION
This product is ETL listed and suitable only for indoor dry locations
and approved for use at any height above the finished floor.
This product is intended to be used with LBL Monorail system.
This instruction is for the following models:
Onyx Cylinder (HJ176ON_1B35MRL)
Onyx Dome (HJ177ON_1B35MRL)
OnyxTeardrop (HJ178ON_1B35MRL)
HJ_1B35MRL
1.3
Install the Lamp
1A1A
1
SOCKET
LAMP
NOTE:To reduce the risk of a burn or electric shock
during relamping, disconnect the power to the fixture.
NOTE:Use only your fingers and soft cloth to replace
the lamp.
Use Watt,Type XelogenMAX 35
(Xenon) Bi-Pin Lamp.
1
Push the lamp pins completely into the socket holes.
WARNING: RISK OF FIRE
Never replace a Xenon (Xelogen) lamp with a regular
Halogen lamp.A regular Halogen lamp requires a protective
glass shield.
1
Install the Fixture to Monorail
1A2A
3
2
1
Unscrew the cap from the Fusion Jack adapter.
2
Select a place on the Monorail where the fixture is going to be
FUSION JACK
ADAPTER
CAP
mounted.
3
From the top or bottom, place the Fusion Jack adapter onto
the Monorail.
Replace and tighten the cap to the Fusion Jack adapter. Make
4
sure that the cap is not cross threaded.
1A2B
SAVETHESE INSTRUCTIONS!
FIXTURE
FUSION JACK
ADAPTER
5
Push and screw the fixture Fusion Jack completely into the
5
FUSION JACK
Fusion Jack adapter.
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
2
A Generation Brands CompanyA Generation Brands Company
Loading...