LBL Lighting Onyx Teardrop User Manual
Installation Instructions for
980ONYXW
Onyx Wall
Wall
GP I :ENERAL RODUCT NFORMATION
This product can mount to either a 4" square electrical box with
round plaster ring or an octagon electrical box.
This product is suitable for indoor dry locations only.
This product can be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
This instruction is for the following models:
Onyx Cylinder Wall (HW176ON_2G60)
Onyx Dome Wall (HW177ON_2G60)
OnyxTeardropWall (HW178ON_2G60)
HW17_ON_2G60
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1.4
Install the Fixture
1A 1B
2
M3 SET
SCREW
1
1.5MM ALLEN WRENCH
1
Loosen the M3 set screw on side of the(Do Not Remove)
onyx shade with the 1.5MM Allen wrench provided.
ONYX SHADE
3
4
CANOPY
M3 SET SCREW
4
Loosen the two M3 set screws on side of(Do Not Remove)
the canopy with the 1.5MM Allen wrench.
Remove the backplate.
6
3
1.5MM ALLEN WRENCH
BACKPLATE
4
2
Remove the onyx shade.
1
1C
#8-32 SCREW
6
7
1E
5
CANOPY
M3 SET SCREW
BACKPLATE
5
Line up two backplate holes with the electrical box holes.
6
Mount the backplate to the electrical box with the two #8-32
6
ELECTRICAL BOX HOLE
screws provided.
7
Connect the green wire to a suitable ground in accordance
with local electrical codes.
1D
8
11
1.5MM ALLEN WRENCH
11
Place the fixture canopy onto the backplate. Level the fixture
vertically and tighten the two M3 set screws with the 1.5MM
Allen wrench to secure the fixture in place.
9
8
Connect the white fixture wire to the neutral power line wire
with a wire nut.
9
Connect the black fixture wire to the hot power line wire with
a wire nut.
10
Place all wires and wire nut connections inside the electrical
box.
2
Loading...