LBL Lighting Omni w Cover Small LED User Manual
Installation Instructions for
980OMNISW-D
Small Omni (LED)
Wall
GP I :ENERAL RODUCT NFORMATION
This product is suitable for damp locations.
This product can mount to either a 4" square electrical box with
round plaster ring or an octagon electrical box.
This product can be dimmed with a low-voltage electronic dimmer.
Power consumption is rated at 10 watts.
LW559
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1.0
Install the Fixture
MOUNTING PLATE
2
3
Connect the ground wire to a suitable ground in accordance
1
with local electrical codes.
2
Connect the white wire to the neutral power line wire.
3
Connect the black wire to the hot power line wire.
1B1A
5
NOTE:Use the universal round crossbar provided if the
electrical box holes do not line up with the backplate.
4
Place all wires and wire nut connections properly inside the
electrical box.
5
5
Screw the backplate to the electrical box.
1
Install the Shade
1C
SCREW
WASHER
ANCHOR
Line up the anchor with the center of the mounting plate hole
6
and push the anchor into the wall up to the threads.
Screw the anchor the rest of the way in with a screwdriver.
7
8
Secure the mounting plate to the anchor with the screw and
washer provided.
2A
ALLEN
WRENCH
4
SHADE
SUPPORT
ARM
3
SHADE
2
SHADE
SUPPORT
ARM
1
Use the Allen wrench to remove the upper shade support arm.
2
Place the shade into the slot in the lower shade support arm.
3
Line up the slot in the upper shade support arm with the top
of the shade.
Use the Allen wrench to attach the shade support arm to the
4
top of the fixture.
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
2
A Generation Brands Company
Loading...