LBL Lighting Omni w Cover Small User Manual
Installation Instructions for
980OMNISW
Small Omni
Wall
GP I :ENERAL RODUCT NFORMATION
This product is suitable for damp locations.
This product can mount to either a 4" square electrical box with
round plaster ring or an octagon electrical box.
This product can be dimmed with a standard incandescent dimmer.
Install the Fixture
JW559
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1.1
1A
NUT
1
Assemble the crossbar by screwing the crossbar nipple to the
cross bar and secure it by tightening the nut.
CROSSBAR
NIPPLE
CROSSBAR
ASSEMBLY
1B
#8-32 SCREW
2
CROSSBAR
ASSEMBLY
2
1C
MOUNTING PLATE
5
6
3
Feed the fixture wires through the mounting plate side hole.
4
Connect the ground wire to a suitable ground in accordance
with local electrical codes.
5
Connect the white wire to the neutral power line wire.
6
Connect the black wire to the hot power line wire.
ELECTRICAL BOX HOLE
2
Mount the crossbar assembly to the electrical box holes with
the two #8-32 screws provided.
1
1D
1E
MOUNTING PLATE
LOCK
WASHER
NUT
THREADED
NIPPLE
7
Place all wires and wire nut connections properly inside the
electrical box.
8
Mount the housing to the crossbar nipple with the nut and lock
washer provided.
SCREW
WASHER
ANCHOR
9
Line up the anchor with the center of the mounting plate hole
and push the anchor into the wall up to the threads.
10
Screw the anchor the rest of the way in with a screwdriver.
11
Secure the mounting plate to the anchor with the screw and
washer provided.
2
Loading...