Installation Instructions for
980OMNISWO-D
Small Omni (LED)
Outdoor
GP I :ENERAL RODUCT NFORMATION
This product is suitable for wet locations.
This product can mount to either a 4" square electrical box with
round plaster ring or an octagon electrical box.
Power consumption is rated at 10 watts.
This product can be dimmed with a low-voltage electronic dimmer.
LW583, LW559
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1.0
Prepare the Fixture for Installation
1
1
1
Remove the six cap screws around the perimeter of the cover.
Lift the cover off the fixture body.
2
1
1
1
1
1B1A
3
3
3
Remove the four screws on the reflector.
Lift the reflector out of the fixture body.
4
3
3
1
Install the Fixture
2A
SCREW
CROSSBAR
POWER LINE AND
GROUNDWIRES
1
Feed the power line wires and ground wire through the nipple
in the crossbar and screw the crossbar to the electrical box.
2B
3
2C
5
CAULK
4
ANCHOR
Install the anchor for the lag bolt at the point marked on the
4
wall.
5
For wet locations: Apply a thick bead of caulk around the
anchor point and the electrical box.
2D
2
2
Place the housing on the crossbar nipple.
3
Mark the location of the end holes in the housing onto the
wall and remove the housing.
7
RUBBER WASHER
LAG BOLT
6
6
Mount the housing to the crossbar nipple with the nut and
METAL WASHER
lock washer provided.
7
Anchor the housing to the wall with a lag bolt through the
metal and rubber washers provided.
Do not overtighten the lag bolt.
2
Install the Protective Cover
2E
9
10
8
Connect the white wire to the neutral power line wire.
8
9
Connect the black wire to the hot power line wire.
10
Connect the green wire to a suitable ground in accordance
with local electrical codes.
2F
11
11
3A
2
2
1
Reinstall all the cap screws around the perimeter of the cover.
2
2
2
2
Install the Decorative Shade (Optional)
4A
ALLEN WRENCH
4
SUPPORT ARM
3
DECORATIVE
COVER
11
Reinstall the reflector into the housing and tighten all four
11
11
screws to hold it in place.
2
SUPPORT ARM
1
Use the Allen wrench to remove the upper shade support arm.
Place the shade into the slot in the lower shade support arm.
2
Line up the slot in the upper shade support arm with the top
3
of the shade.
4
Use the Allen wrench to attach the shade support arm to the
top of the fixture.
3
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
4
A Generation Brands Company
Loading...