LBL Lighting MO Telescoping Rigid Standoff User Manual

Installation Instructions for

980MRLTSP

Telescoping Rigid Standoffs

Monorail

GP I :ENERAL RODUCT NFORMATION

This product is suitable for dry locations only.

This product must be used with LBL Monorail systems only.

This instruction is for the following models:

Monorail Support 2.6" - 4" (HANGER-ADJ-_1)
Monorail Support 6" - 10" (HANGER-ADJ-_2)
Monorail Support 12" - 24" (HANGER-ADJ-_3)
Monorail Support 24" - 48" (HANGER-ADJ-_4)
Monorail Support 48" - 96" (HANGER-ADJ-_5)

Above model numbers with -BJ suffix (vaulted ceilings).

HANGER-ADJ-_(-BJ)

1.3

Install the Ceiling Anchor

1A

1A

4

ANCHOR

CEILING

1

Select a location on the ceiling where the Monorail is to be
mounted.

2

One way of marking the standoff locations on the ceiling is to
lay the Monorail on the floor underneath of the selected
location and by using a plumb bob pointing on the center of
the Monorail, mark the points on the ceiling.

3

Another way is to hold the Monorail directly against the ceiling
and mark the standoff points on the ceiling.

4

Tap the anchors at the marked points up to the threaded
portion with a hammer.

1B

1B

5

5

Screw the anchors in the rest of the way with a Phillips
screwdriver.

1B1C

ANCHOR

WASHER

#8 SCREW

6

THREADED NIPPLE

6

Insert the #8 screw into the threaded nipple and washer.
Tighten the #8 screw completely into the anchor to secure the
washer and threaded nipple.

7

Repeat these steps for each standoff.

1

Attach the Vault Adapter (Optional)

1A

2A

Attach the Telescoping Standoff

1A

3A

SUPPORT POST

SUPPORT POST

M4 SET
SCREW

1

Loosen the M4 set screw on the support(Do Not Remove)

1

2 MM ALLEN
WRENCH

post and remove the support post from the ball joint.

1A2B

M4 SET
SCREW

1

Loosen the M4 set screw on the support(Do Not Remove)

1

2 MM ALLEN
WRENCH

post with the 2 MM Allen wrench provided and remove the
support post.

1A3B

THREADED NIPPLE

2

SUPPORT POST

2

Screw the support post completely to the threaded nipple.

1A2C

3

SUPPORT POST

THREADED NIPPLE

BALL JOINT

2

SUPPORT POST

2

Screw the support post completely to the threaded nipple on

THREADED NIPPLE

the anchor (above) or the ball joint (shown in figure 2C).

1A3C

SUPPORT POST

3

STANDOFF ROD

M4 SET SCREW

2 MM ALLEN
WRENCH

3

Reattach the ball joint to the support post.

Repeat these steps for each standoff.

4

3

Reattach the standoff rod to the support post.

4

Repeat these steps for each standoff.

2