LBL Lighting MO Pass-Through Direct-Feed Surf Elec Xfmr 300w User Manual

Installation Instructions for
920MOPSET
Pass-Through Surface ElectronicTransformer
GP I :ENERAL RODUCT NFORMATION
This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor.
A typical installation is shown. Specific installation must be in accordance with local electrical codes.
This product may be dimmed only with a low voltage electronic dimmer. Using a dimmer not designed for low voltage electronic applications may work initially, but could eventually cause transformer failure and will void the warranty.
dimmer manufacturer.
This product is intended for use with Tech and LBL Lighting low-voltage lighting systems only.
Read all instructions thoroughly. Read "Important Safety Information" below before proceeding with the installation.
The dimmer must be derated as indicated by the
This product requires installation by a qualified electrician. Before installing be sure to read all instructions and TURN THE POWER TO THE ELECTRICAL BOX OFF.
1.1
CAUTION—RISK OF FIRE
Important Safety Information
To reduce the risk of fire and burns, do not install this lighting system where the uninsulated open bus bar conductors can be shorted or contact any conductive materials.
To reduce the risk of the system overheating and possibly causing a fire, make sure all the connections are tight.
Do not install fixture assemblies closer than six inches to curtains or similarly combustible materials.
SAVE THESE INSTRUCTIONS!
Turn the electrical power off before modifying the lighting system in any way.
The fixtures used with the system must be identified for used with the corresponding system.
Load the circuit of the remote transformers to no more than the maximum rated capacity as specified.
To reset the electronic surface transformer, turn the power off then on (main power, breaker panel, or wall switch).
1
Install the Transformer
1A1A
Connect the Transformer to the MonoRail
1A
2A
THUMB RELEASE BUTTON
1
Press the thumb release buttons to separate the transformer housing.
1A
1B
2
4
2
Connect the mounting plate ground wire to a suitable ground in accordance with local electrical codes.
THUMB RELEASE
3
BUTTON
1
3
MONORAIL
1
Place the MonoRail into the bushing.
2
Replace the bushing cap.
3
Screw the tool into the bushing cap.
4
Secure the MonoRail by using the tool to tighten the bushing cap.
1A
2B
TOOL
2
TOOL THREADS
BUSHING
3
Connect the white transformer wire to the neutral power line wire with a wire nut.
4
Connect the black transformer wire to the hot power line wire with a wire nut.
1A
1C
5 5
#8-32 SCREW #8-32 SCREW
5
Place all wires and wire nut connections inside the electrical box and mount the transformer to the electrical box with provided #8-32 screws.
1A
1D
TOOL
HOLE
NOTE: The tightening tool must be screwed in
properly and completely in order for the bottom half of the transformer to snap in correctly.
5
Replace the tightening tool by screwing it back in completely.
6
Reassemble the transformer by first aligning the tool and the hole, then push up until it properly snaps back into place.
TOOL
6
Unscrew and remove the bushing cap and the tightening tool.
BUSHING CAP
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.generation-brands.com
© 2013 Generation Brands.All rights reserved. The "Genereation Brands" graphic is a registered trademark of Generation Brands. Generation Brands reserves the right to change specifications for product improvements without notification.
2
A Generation Brands Company
Loading...