LBL Lighting MO Flush Elec Xfmr 60w User Manual
Installation Instructions for
60 Watt Electronic Flexible Power Feed CanopyTransformer
for LED Fixtures
Monorail
GENERAL PRODUCT INFORMATION:
This product is ETL listed only when all the products used are
supplied by LBL Lighting, is suitable only for indoor dry locations
and approved for use at any height above the finished floor.
This product may be dimmed only with a low voltage electronic
dimmer. Using a dimmer not designed for low voltage electronic
applications may cause undesirable noise and potentially shorten
the life of the transformer.
Install the Crossbar
TRANS-SFE60_
700MOPCEN_
980MRLSFELEDFCT
1.3
Minimum volume of the electrical box must be 6 cubic inches (98
cubic centimeters).
This product is intended for use with LBL low voltage lighting
systems only.
Read all instructions thoroughly before beginning installation.
Important Safety Information
To reduce the risk of fire and burns, do not install this lighting
system where the uninsulated open bus bar conductors can be
shorted or contact any conductive materials.
To reduce the risk of the system overheating and possibly causing a
fire, make sure all the connections are tight.
Do not install fixture assemblies closer than 6 inches to curtains or
similarly combustible materials.
Turn the electrical power off before modifying the lighting system in
any way.
The fixtures used with the system must be identified to be used
with the corresponding system.
1A
1
Disassemble the canopy by unscrewing the cap with
nipple until the crossbar has been separated.
1B
CROSSBAR
1
#8-32 SCREW
CROSSBAR
CANOPY
CAP WITH
NIPPLE
Minimum volume of the electrical box must be 6 cubic inches (98
cubic centimeters).
Load the circuit of the surface mount transformer to no more than
the maximum rated capacity as specified.
2
Mount the crossbar to the electrical box with the
provided two #8-32 screws.
3
Pull the power wires out of electrical box for power
connection.
1
Install the Canopy
2A
BUSHING
5
3
Cut the center power feed wires to the desired length.
4
With a sharp knife cut 1" from the end of the wire web
and separate the wires 8" from each other.
Push the power feed wires through the canopy bushings
5
and slide the canopy down the wires.
6
Strip 1/2" off the wire ends.
2B
7
2C
8
8
8
Properly place the transformer, wires, and wire nut
connections into the electrical box.
89
Slide the canopy up and secure it to the electrical box by
screwing the cap with nipple to the crossbar.
CAP WITH NIPPLE
2D
TRANSFORMER
9
8
5
7
Ground the mounting plate in accordance with local
10
8
BUSHING
electrical codes.
8
Connect the red driver wires to the power feed wires.
ALLEN
WRENCH
10
Push the excess power feed wires into the canopy and
9
PLASTIC SCREW
tighten the plastic screw with the provided Allen
wrench.
69
Connect the white driver wire to the neutral power line
wire.
610
Connect the black driver wire to the hot power line
wire.
2
Loading...