LBL Lighting MO Direct Feed Flush Elec User Manual

Installation Instructions for
60 Watt Electronic Direct Power Feed
980MRLSFELEDDCT
CanopyTransformer for LED Fixtures
Monorail
GP I :ENERAL RODUCT NFORMATION
This product is ETL listed only when all the products used are supplied by LBL Lighting, is suitable only for indoor dry locations and approved for use at any height above the finished floor.
This product may be dimmed only with a low voltage electronic dimmer. Using a dimmer not designed for low voltage electronic applications may cause undesirable noise and potentially shorten the life of the transformer.
Minimum volume of the electrical box must be 6 cubic inches (98 cubic centimeters).
This product is intended for use with LBL low voltage lighting systems only.
Important Safety Information
To reduce the risk of fire and burns, do not install this lighting system where the uninsulated open bus bar conductors can be shorted or contact any conductive materials.
To reduce the risk of the system overheating and possibly causing a fire, make sure all the connections are tight.
Do not install fixture assemblies closer than 6 inches to curtains or similarly combustible materials.
Turn the electrical power off before modifying the lighting system in any way.
The fixtures used with the system must be identified to be used with the corresponding system.
Minimum volume of the electrical box must be 6 cubic inches (98 cubic centimeters).
TRANSDIR-SFE60_
1.2
Install the Power Feed Canopy
1A
1A
2
TRANSFORMER
7 7
POWER LINE WIRES
3
5
Load the circuit of the surface mount transformer to no more than the maximum rated capacity as specified.
NOTE: Use the provided universal round crossbar when the
canopy holes do not line up with the electrical box holes.
1
Disconnect power to the electrical box.
2
Connect the white transformer wire to the neutral power line wire with a wire nut.
3
Connect the black transformer wire to the hot power line wire with a wire nut.
4
Connect a suitable ground in accordance with local electrical codes.
5
Connect the canopy wires to the transformer output wires with wire nuts.
6
Place the transformer, wires, and wire nut connections inside the electrical box.
7
Mount power feed canopy to the electrical box with the two #8-32 screws.
1
Connect the MonoRail to the Transformer Canopy
1A
2A
POWER FEED HOUSING
1A2C
1
POWER FEED CAP
2
SCREW
NOTE:The standoffs should be installed to support the
Monorail while connecting Monorail to the power feed canopy. Refer to the instruction provided with the standoffs.
1
Remove the power feed cap from the power feed housing.
Completely back out the screw on the power feed cap.
2
1A2B
MONORAIL
POWER FEED
3
HOUSING
POWER FEED CAP
5
5
Tighten the screw on the power feed cap for proper power
SCREW
connection.
POWER FEED CAP
3
Place the Monorail into the standoffs and power feed housings.
4
Screw the power feed cap completely to the power feed
4
housing. Make sure that the power feed cap is not cross
threaded.
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.
2
A Generation Brands CompanyA Generation Brands Company
Loading...