LBL Lighting MO Curve User Manual
Installation Instructions for
Flexible Vertical Conductive Connectors
MONORAIL
GP I :ENERAL RODUCT NFORMATION
This product is suitable for dry locations only.
Adjust the Angle
950MOFXV
1.0
1.0
1.1
1A1A 1A1B
JOINING WIRES
1
SET SCREWS
The joining wires on the flexible connectors are precut for a 90-degree bend. For any angle other than
90 degrees, follow these instructions to adjust the
wires. Otherwise, skip ahead to section 2.
1
Loosen the inner set screws on one connector with an
Allen wrench.
2
Pull the wires out of the connector.
3
4
5
STRIPPED
WIRES
4
Trim the wires to the proper length and strip off the last
3/8” of the insulation.
Insert the stripped wires into the connector.
Tighten the set screws with an Allen wrench to secure the
wires.
5
SET SCREWS
1
Connect the Monorail Sections
1A2A
1
2
SET SCREWS
2
1
1
Push the connectors completely into the MonoRail.
2
Tighten all four outer set screws with an Allen wrench. To
avoid heat build up and corrosion, make sure all set
screw connections are tight.
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.generation-brands.com
© 2012 Generation Brands.All rights reserved. The "Genereation Brands"
graphic is a registered trademark of Generation Brands. Generation Brands
reserves the right to change specifications for product improvements without
notification.
2
A Generation Brands Company
Loading...