Installation Instructions for
980HWBEACHCCF
Hollywood Beach Ceiling (Compact Fluorescent)
Ceiling
GP I :ENERAL RODUCT NFORMATION
This product can mount to either a 4” square
electrical box with a round plaster ring or an
octagon electrical box.
This product is suitable for damp locations.
This instruction shows a typical installation.
Install the Fixture
1A
CROSSBAR
ELECTRICAL
BOX
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURNTHE POWER TO THE
ELECTRICAL BOX OFF.
1C
CAUTION - RISK OF FIRE
PC651_CF
1.0
1 1
#8-32 SCREW #8-32 SCREW
1
Mount the crossbar to the electrical box with the two
#8-32 screws.
1B
THUMB
SCREWS
2
2
Unscrew and remove the three thumb screws and gently
remove the diffuser.
DIFUSER
3
4
3
Connect the mounting plate ground wire to a suitable
ground according to local electrical codes.
4
Connect the white fixture wire to the neutral power line
wire with a wire nut.
5
Connect the black fixture wire to the hot power line
wire with a wire nut.
1
5
1D
KNURLED NUT KNURLED NUT
6
Place all wires and wire nut connections inside the
electrical box.
7
Mount the fixture to the ceiling by installing it onto
the crossbar and securing it tightly with the knurled
nuts.
2B
PEGS
2
2
Install the diffuser and align the holes to the pegs on
the shade.
3
Secure the diffuse by reinstalling and tightening the
three thumb screws.
DIFFUSER
Install the Lamp and Diffuser
2A
LAMPSOCKET
Use Volt, Type Gu24 BaseMAX 27120 Watt
Self Ballasted Spiral Compact
Fluorescent Lamps.
NOTE: To re-lamp, reverse the section 2 instructions
to remove the diffuser and gain access to the lamps
and sockets.
SAVE THESE INSTRUCTIONS!
Statement of Warranty
LBL Lighting warrants all products manufactured to
be free from defects in material and workmanship
under normal use for 3 years after the date of
original purchase. This warranty only applies when
components, including power supplies, have been
provided by LBL Lighting.
Upon confirmation of a defect or failure, at our
discretion we will repair or replace the item or will
refund your purchase price if repair or replacement is
not possible or practical. Our warranty covers only
the product itself; we will assume no liability for
labor costs, installation costs, or other losses.
CAUTION: To reduce the risk of a burn or electric
shock during re-lamping, disconnect the power to
the fixture.
1
Push the lamp pins into the large portion of the socket
slots and rotate it clockwise to lock it in place.
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2012 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
2
A Generation Brands Company