Page 1
Installation Instructions for
980TARA18O
Henry 18 Outdoor
Outdoor
GP I :ENERAL RODUCT NFORMATION
This product is suitable for wet locations.
This product can mount either to a 4” square electrical box with a
round plaster ring or an octagon electrical box.
This product may be dimmed with a low-voltage electronic dimmer.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
OD821_
1.0
Install the Fixture
1A 1B
MOUNTING
PLATE
1
1
SET SCREW
ALLEN WRENCH
#8-32 SCREW
3
3
MOUNTING
PLATE
1
With the Allen wrench provided, back out (do not fully
remove) the set screws at the base of the fixture.
2
Remove the mounting plate from the back of the
fixture.
3
Attach the mounting plate to the electrical box using
the two #8-32 screws provided.
1
Page 2
1C
1D
SCREW
ANCHOR
ANCHOR
WASHER
WASHER
SCREW
4
Verify that the mounting plate is level before continuing.
5
Line up an anchor tip with the center of a mounting
plate hole, and push the anchor into the wall up to the
threads.
6
6
Screw the anchors in the rest of the way with a Phillipshead screwdriver.
Repeat steps 5-6 for the other anchor.
67
68
Slide a #8 screw through a washer and screw it into an
anchor.
69
Repeat for the other anchor to secure the mounting
plate to the wall.
2
Page 3
1E
DRIVER
11
10
12
10
Connect the mounting plate ground wire to a suitable
ground in accordance with local electrical codes.
1G
11
Connect the white (blue) driver wire to the neutral
power line wire with a wire nut.
12
Connect the black (brown) driver wire to the hot power
line wire with a wire nut.
1F
13
15
For wet locations, caulk around the base with
waterproof construction sealant.
14
13
Place the driver flat inside the fixture and hook the top
of the fixture to the top of the mounting plate and
swing the bottom of the fixture toward the plate until it
is flush with the wall.
14
With the allen wrench, tighten the set screws at the
bottom of the fixture to secure it to the mounting plate.
3
Page 4
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
4
Loading...