LBL Lighting Hanna User Manual
Installation Instructions for
980HANNAWD
Hanna Wall (LED)
Wall
GP I :ENERAL RODUCT NFORMATION
This product is suitable for damp locations.
This product can mount either to a 4” square electrical box with a
round plaster ring or an octagon electrical box.
This product may be dimmed with a low-voltage electronic dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURNTHE POWER TO THE
ELECTRICAL BOX OFF.
W 822_S
1.0
Install the Mounting Plate
1A
1
MOUNTING
PLATE SCREW
1
MOUNTING
PLATE
1B
#8-32 SCREW
MOUNTING
PLATE
3
3
1
1
Remove the two mounting plate screws.
2
2
Remove the mounting plate from the back of the
fixture.
3
23
Install the mounting plate onto the electrical box with
the two #8-32 screws provided.
1
Install the Fixture
2A
DRIVER
3
1
2
1
Connect the mounting plate ground wire to a suitable
ground according to local electrical codes.
2
Connect the black driver wire to the hot power line wire
with a wire nut.
3
Connect the white driver wire to the neutral power line
wire with a wire nut.
4
Properly place the driver, all wires, and wire nut
connections into the electrical box.
5
Mount the fixture by sliding it back onto the mounting
plate and reinstalling the fixture screws (reversal of
figure 1A).
1
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
2
A Generation Brands Company
Loading...