Page 1
Installation Instructions for
980FSJ11PRW
Fusion Jack 11-Port Round Canopy
Ceiling
GP I :ENERAL RODUCT NFORMATION
This product is suitable for dry locations only.
This product is dimmable with a low-voltage electronic dimmer.
IMPORTANT! Do not install any head or pendant closer
than 12 inches to this canopy. Heat from the lamp may
damage the wood.
CK011RD-FJ_
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1.0
Install the Backplate
1A
1
1
1
Remove all the button head screws around the canopy.
1B
BACKPLATE
1C
BACKPLATE
1
3
3
4
4
4
2
Lift the backplate out of the canopy.
3
Feed the power line wires through the hole in the middle of
the backplate.
4
Mount the backplate to the electrical box with the two long
#8-32 screws provided.
1
Page 2
Install the Canopy
1D 2A
8
5
7
1 1
1
SAFETY
CABLE
SAFETY
BRACKETS
6
8
2
5
Line up an anchor with the center of a backplate hole and
7
push the anchor in up to the threads.
2
6
Screw the anchor the rest of the way in with a screwdriver.
7
2
Secure the backplate to the anchors with the screws and
washers provided.
8
2
Repeat steps 5-7 for all six anchor holes.
2
1
Hook a safety cable through the safety brackets on each end
of the canopy and backplate.
2
Page 3
Install the Fixtures
2B 3A
FUSION JACK PORT
1
2
Screw a Fusion Jack connector into each Fusion Jack port.
3
2
4
1
FUSION JACK
CONNECTOR
22
Connect the black fixture wire to the hot power line wire
with a wire nut.
2
3
Connect the white fixture wire to the neutral power line wire
with a wire nut.
2
4
Connect the green wire and bare copper wire to a suitable
ground according to local electrical codes.
2C
5
5
2
5
Line up the canopy to the backplate and install all the button
head screws.
5
3
Page 4
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
4
A Generation Brands Company
Loading...