LBL Lighting Aviva 26 User Manual
Installation Instructions for
980AVI26O
Aviva 26 Wall
Outdoor
GP I :ENERAL RODUCT NFORMATION
This product is suitable for wet locations.
This product can mount either to a 4” square electrical box with a
round plaster ring or an octagon electrical box.
This product may be dimmed with a low-voltage electronic dimmer.
This product must only be mounted vertically in wet locations.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
O 787_D
1.0
Install the Fixture
1A
FIXTURE SCREW
FIXTURE SCREW
1
1
MOUNTING
PLATE
1B
#8-32 SCREW
3
MOUNTING
PLATE
3
Attach the mounting plate to the electrical box using
the two #8-32 screws provided.
3
1
Remove the fixture screws located on the top and
bottom of the fixture base.
2
Remove the mounting plate from the fixture base.
1
1C
1E
FIXTURE BASE
6
4
5
4
Connect the mounting plate ground wire to a suitable
ground according to local electrical codes.
5
Connect the brown (black) ballast wire to the hot power
line wire with a wire nut.
6
Connect the blue (white) driver wire to the neutral
power line wire with a wire nut.
1D
FIXTURE SCREW
8
8
FIXTURE SCREW
1
9
For wet locations, caulk around the base with
waterproof construction sealant.
SAVETHESE INSTRUCTIONS!
7
Properly place the driver, all wires, and wire nut
connections into the fixture base.
8
Mount the fixture by placing it back onto the mounting
plate and reinstall the fixture screws.
1
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
2
A Generation Brands Company
Loading...