LBL Lighting Athena WCF User Manual
Installation Instructions for
980ATHENWCF
Athena Wall (Compact Fluorescent)
Wall
GP I :ENERAL RODUCT NFORMATION
This product can mount to either a 4" square electrical box with
round plaster ring or an octagon electrical box.
This product is suitable for damp locations.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
PW5498_13Q_
1.4
Install the Fixture
1A 1B
3
MOUNTING
PLATE
4
CENTER HOLE
NOTE:Use the provided crossbar assembly if the
mounting plate holes do not match with the electrical box
holes.
1
Feed the fixture wires through the mounting plate center hole.
2
In accordance with local electrical codes, make sure that the
mounting plate is grounded.
5
6
MOUNTING
PLATE
#8-32
SCREW
Place all wires and wire nut connections properly inside the
electrical box.
Install the mounting plate to the electrical box with the
provided two #8-32 screws.
6
6
ELECTRICAL
BOX HOLE
3
Connect the fixture white wire to the neutral power line wire
with a wire nut.
4
Connect the fixture black wire to the hot power line wire with
a wire nut.
1
Install the Lamp & Shade
2A
LAMP
1
SOCKET
Use WattType Quad TubeMAX 13
G24Q-1 Base Compact Fluorescent Lamp.
1
Push the lamp pins completely into the socket holes.
2B
GLASS
SHADE
2
THREADED
CAP
2
From bottom of the mounting plate slide the glass shade up
3
onto the threaded nipple.
3
Replace and tighten the cap completely to the exposed
threaded nipple to secure the glass shade in place.
NIPPLE
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
2
A Generation Brands Company
Loading...