LBL Lighting Ashland User Manual
Installation Instructions for
980ASHLNDW
Ashland Wall (LED)
Wall
GP I :ENERAL RODUCT NFORMATION
This product is suitable for damp locations.
This product can mount either to a 4” square electrical box with a
round plaster ring or an octagon electrical box.
This product may be dimmed using a low voltage electronic dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURNTHE POWER TO THE
ELECTRICAL BOX OFF.
WS696_LED
1.0
Install the Fixture
1A
1 1
SCREW
1
Attach the mounting plate to the electrical box using
the two #8-32 screws provided.
MOUNTING
PLATE
1B
DRIVER
2
4
FIXTURE
2
Connect the mounting plate ground wire to a suitable
ground in accordance with local electrical codes.
3
MOUNTING
PLATE
3
Connect the white driver wire to the neutral power line
wire with a wire nut.
4
Connect the black driver wire to the hot power line wire
with a wire nut.
1
1C
5
ALLEN WRENCH
5
With the Allen wrench provided, back out (do not fully
SET SCREW
remove) the set screw at the base of the fixture.
1D
8
SET SCREW
SAVE THESE INSTRUCTIONS!
ALLEN WRENCH
NOTE: This fixture can be installed upside down.
6
Properly place the driver, all wires, and wire nut
connections into the electrical box.
7
Hook the top of the fixture to the top of the mounting
plate and swing the bottom of the fixture toward the
plate until it is flush with the wall.
8
Tighten the set screw at the bottom of the fixture.
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2013 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
2
A Generation Brands Company
Loading...