LBL Lighting Apex Swivel User Manual

Installation Instructions for
980FSJAPXS
Apex Swivel
Fusion Jack
GP I :ENERAL RODUCT NFORMATION
This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor.
Colored and Dichroic lenses, or Diffuser, Linear Spread, and Soft Focus Lenses, or Structure Louvers are the compatible accessories.
WARNING: Risk of Fire. Hot Surface. Install the fixture
at least 6" (Inches) away from wall, curtains and combustible materials. Maintain at least 9" (Inches) of clearance directly in front of the fixture.
AVERTISSEMENT: Risque du feu. Surface Chaude.
Installez le montage au moins 6" (Pouces), 153 mm, loin du mur, des rideaux et des matériaux combustibles.Maintenez au moins 9" (Pouces), 230 mm, de dégagement directement devant le montage.
HD162_1A50FSJ
CAUTION - RISK OF FIRE
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
1.4
Install the Lamp
1A
1
6
THUMB SCREWS
NOTE:To reduce the risk of a burn or electric shock
during relamping, disconnect the power to the fixture.
1
Loosen the thumb screws on the socket.
2
Slide the socket back.
Use Watt MR16 Front Cover
MAX 50
Halogen Lamp.
3
Push the MR16 lamp pins all the way into the socket.
4
Put the optional accessory lens into the ring.
5
Slide the socket forward so that the edge of the lamp sits
4
2
3
LAMP
5
ACCESSORY LENS
inside the ring.
6
Tighten the thumb screws on the socket.
1
IMPORTANT SAFETY INSTRUCTIONS
Halogen Lamp General Information
To reduce the risk of fire, electrical shock,exposure to
excessive UV radiation, or injury to person:
– Use this fixture indoors only.
– Do not look directly at the lighted lamp.
– Do not remain in light if skin feels warm.
– Risk of fire: Use only the type of lamp and maximum wattage
indicated in this instruction manual.
– Never cover the halogen lamp with anything other than a LBL
Lighting lamp shield and never place flammable material close to your fixture.
– Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
– Do not touch the fixture shades or lamp shield while the fixture
is on.These surfaces may be HOT.
– A new halogen lamp may smoke slightly when it is used for the
first time.This is perfectly normal; the protective coating is simply being vaporized.
TwoTips For Prolonging Halogen Lamp Life
– First avoid touching the lamp with bare hands during installation.
Any contaminant, even the oil from your hands can deteriorate
the lamp. Rubbing alcohol can be used to remove any contaminant.
– Second, do not run the lamps at full power when you do not need
to. However, if dimming the fixture for an extended period of time, occasionally bring the light up to full brightness for a few minutes to complete the halogen cycle.
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2008 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.
A Generation Brands Company
2
Loading...