LBL Lighting Aliseo Wall User Manual

Installation Instructions for
980ALISEW
Aliseo
Wall Sconces
GENERAL PRODUCT INFORMATION:
This product is suitable for indoor dry locations only.
This product can be dimmed with a standard incandescent dimmer.
CAUTION - RISK OF FIRE
This product requires installation by a qualified electrician. Before installing be sure to read all instructions and TURN THE POWER TO THE ELECTRICAL BOX OFF.
JWAP13OPSC240
1.3
Install the Fixture
1A
GLASS SHADE
THUMB SCREW
2
1
END CAP
MOUNTING PLATE
1B
MOUNTING PLATE
4
3
5
1
Remove the two thumb screws and end caps from the top and
1
bottom of the glass shade
Remove the glass shade.
2
In accordance with local electrical codes, make sure that the
3
mounting plate is grounded.
4
Connect the fixture white wire to the neutral power line wire with a wire nut.
5
Connect the fixture black wire to the hot power line wire with a wire nut.
1
1
1C
2B
3
GLASS SHADE
7
#8-32 SCREW
6
Place all wires and wire nut connections properly inside the
7
6
ELECTRICAL BOX HOLE
electrical box.
Align the mounting plate holes with electrical box holes and
7
tighten with two #8-32 screws to secure the fixture in place.
Install the Lamp & Shade
2A
2
END CAP
3
Place the glass shade onto the mounting plate.
2
3
While supporting the glass shade in place replace the caps and
THUMB SCREW
thumb screws on top and bottom of the shade. Make sure the thumb screws are tight to secure the glass shade in place.
NOTE: Do not over tighten the thumb screws which may
cause the glass shade to break.
Use MAX 40 Watt Type B10 E12 Base Candelabra Lamp With Each Socket
Screw the lamps into the sockets.
1
LAMP
1
SOCKET
SAVE THESE INSTRUCTIONS!
1
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2008 LBL Lighting. All rights reserved. The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.
2
A Generation Brands Company
Loading...