LBL Lighting Alban W User Manual
Installation Instructions for
980ALBANW
Alban Bath (Fluorescent)
Wall
GP I :ENERAL RODUCT NFORMATION
This product is suitable for damp locations.
This product can mount either to a 4” square electrical box with a
round plaster ring or an octagon electrical box.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
B 824_A
1.0
Install the Mounting Plate
1A
FIXTURE SCREW
FIXTURE SCREW
1
1
MOUNTING
PLATE
1B
#8-32 SCREW
MOUNTING
PLATE
3
Attach the mounting plate to the electrical box using
the two #8-32 screws provided.
3
3
1
Remove the fixture screws located on the top and
bottom of the fixture base.
2
Remove the mounting plate from the fixture base.
1
Install the Lamp and Shade
2A
END CAP
ALLEN
SCREW
1
Remove the two Allen screws located on the rear of the
ALLEN
WRENCH
FIXTURE
BRACKET
3
1
FIXTURE
BASE
end caps with the Allen wrench provided.
2
Remove the two end caps.
2B
SOCKET SOCKET
LAMP
2C
END CAP
ALLEN
SCREW
5
Carefully slide the shade into the fixture base brackets.
6
Reinstall the end caps and Allen screws to secure the
ALLEN
WRENCH
FIXTURE
BRACKET
5
6
SHADE
shade in place (reversal of figure 2A).
7
Follow this section to re-lamp the fixture.
FIXTURE
BASE
3
SOCKET
4
LAMP
CAUTION: To reduce the risk of a burn or electric
shock during relamping, disconnect the power to
the fixture by turning the wall switch off.
Use type T5 High OutputMAX 24 Watt
linear fluorescent lamp.
3
Align the lamp pins with socket slots.
4
Push the pins all the way into the socket slots and rotate
the lamp until it clicks into place.
2
Loading...