LBL Lighting 4 Round Dual-Post Direct Power feed Canopy User Manual
Installation Instructions for
980MRL4RDDPFC
4" Round Dual-Post Direct Power Feed Canopy
Monorail
GP I :ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
Minimum volume of the electrical box must be 6 cubic inches (98
cubic centimeter).
Install the Power Feed Canopy
1A1A
HOT 1
1
COM 1
HOT 2
2
4
3
COM 2
1A1B
#8-32 FLAT
HEAD SCREW
REMOTECNPYDIRDF_
6
6
1.2
CENTER CONTACT
NOTE:The low voltage wires should be present in the
electrical box prior to these steps. Refer to the instructions
provided with the remote transformer to install the remote
transformer and low voltage wires.
NOTE: Use the provided universal round crossbar when
the canopy holes do not line up with the electrical box holes.
1
Starting with one post, connect the wire attached to the
center contact to the low voltage wire marked "HOT 1" with a
wire nut.
Connect the other wire of the same post to the low voltage
2
wire marked "COM 1" with a wire nut.
3
Connect the wire attached to the center contact of the other
post to the low voltage wire marked "HOT 2" with a wire nut.
4
Connect the other wire of the post to the low voltage wire
marked "COM 2".
CANOPY
3/32 ALLEN WRENCH
5
Place all wires and wire nut connections inside the electrical
box.
6
Tighten the two provided #8-32 flat head screws to the
electrical box holes with the 3/32 Allen wrench to secure the
canopy in place.
1
Install the Monorail the Power Feed
Canopy
1A12A
MONORAIL
M3 SET SCREW
STRAIGHT ISOLATING CONNECTOR
1
2
1.5 MM ALLEN
WRENCH
Push two Monorail sections completely onto the straight
isolating connectors.
2
Tighten the M3 set screws firmly with the provided 1.5 MM
Allen wrench. the set screws whichDo Not Over Tighten
may strip the thread.
1A2B
POWER FEED
HOUSING
3
POWER
FEED CAP
4
SCREW
MONORAIL
1A2C
5
6
POWER FEED CAP
7
STRAIGHT ISOLATING CONNECTOR
NOTE: It is recommended that two people install the
Monorail sections to the standoff and power feed
housings.
Place the combined Monorail sections into the standoffs and
5
power feed housings so that the straight isolating connector
section is located in the middle of the two power feed
housings. Make sure that the Monorail sections are
electrically isolated from each other.
6
Screw the power feed caps completely to the power feed
housings. Make sure that the power feed caps are not cross
threaded.
Tighten the screw on the power feed caps for proper power
7
connection.
SCREW
NOTE:The standoffs should be installed to support the
Monorails while connecting Monorails to the power feed
canopy. Refer to the instruction provided with the
standoffs.
3
Remove the power feed caps from the power feed housings.
4
Completely back out the screw on the power feed caps.
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
2
A Generation Brands Company
A Generation Brands Company
Loading...