LAWN STAR LSCM 38-5 Operating Instructions Manual
[Type a quote from the document or the summary of an interesting point. You can position the text box
anywhere in the document. Use the Drawing Tools tab to change the formatting of the pull quote text
box.]
CYLINDER PUSH MOWER
OPERATING INSTRUCTIONS
MODEL LSCM 38-5
Thank you for purchasing the Lawn Star cylinder push mower which is one of the finest push
cylinder mowers today’s technology can produce. Before you begin using it, please read this
manual carefully and familiarise yourself with the control and proper use of this product to
ensure you get the best possible performance from it.
SAFETY PRECAUTIONS
Never use the mower while people, especially children or pets, are nearby.
Always walk never run.
Do not operate the mower when barefoot or wearing open sandals.
Thoroughly inspect the area where the mower is to be used and remove all objects, which
may be thrown by the machine.
Always be sure of your footing on slopes. Do not mow excessively steep slopes.
Keep all nuts, bolts and screws tightened. Always ensure that the equipment is in a safe
working condition.
Replace worn or damaged parts immediately.
Keep hands and feet clear of the rotating blades.
Use caution when adjusting the blades.
PREPARATION FOR USE
Carefully remove the machine from packaging and check that you have all the following items:
Lawnmower
Bottom handle
Top handle
2 Handle Centres
6 Nuts
6 Bolts
Operating instructions
Should any parts be missing or damaged, please contact the consumer care hotline on 0860LAWNSTAR (0860 52967827) for assistance. We also have a network of Approved Lawn
Star Service Agents who you can contact for service and advice.
Assembly
A Attach bottom handle 1 to the mower.
B Assemble the top handle 2 to the handle centres 3, and fit to handle bottom 1.
E Attach grass catcher hooks 9 to mower and fit grass catcher 10 (grass catcher not supplied
as standard but can be purchased as an optional extra from any Lawn Star dealer)
ADJUSTING THE CUTTING HEIGHT (FIGURE C)
Loosen the knobs on either side of the roller and adjust both sides equally, in the direction of the
arrow, to obtain the desired cutting height. Tighten the knobs.
Loading...