
Lava Parallel Bi-directional
Installation Manual
LAVABI-DIRECTIONAL PARALLEL BOARD
LAVA
COMPUTERS
MADE IN
CANADA
Rev.B00
P.N.MOKO L4.4C

Parallel Configuration
1. Determine the number of
parallel ports already installed
in your system.
2. If you have two parallel ports
already installed,set the Parallel
Bi-directional card to LPT 0 address 3BC (ignore IRQ
jumper).The Parallel Bidirectional card will now act as
your PC's primary parallel port
and will be seen by your
operating system as LPT 1. All
other LPT port designations will
be increased by a factor of 1.
1. Il faut determiner combien
des ports parallèle en votre
système.
2. Si vous avez deux ports
parallèle, ajouter le Port de
Lava pour LPT0 (03BC hex).
N'importe quoi l'IRQ. Le Port
de Lava sera le Port Parallèle,
primaire (LPT 1). Les autres
sera LPT 2 (0378 hex) et LPT 3
(0278 hex).
3. Si vous avez un port parallèle,
ajoutez le Port de Lava pour
3. If you have one parallel port
installed, set the configuration
jumpers for LPT 2 (address 278),
IRQ 5 as shown.
4. If you have no parallel ports
installed, set the configuration
jumpers for LPT 1 (address 378)
IRQ 7, as shown.
5. If desired,the Parallel Bidirectional card may be
reconfigured for either bidirectional mode or for output
LPT2 (0278 hex), IRQ 5.
4. Si vous n'avez pas un port
parallèle, ajoutez le Port de
Lava pour LPT 1 (0378 hex),
IRQ 7 [default].
5. Si vous desirez, le Port
Parallèle peut utilizer la
mode bi-directionelle, ou
uni-directionelle.
only.

Lava
Technical Support
9:00 am to 5:30 pm Monday to Friday (Eastern Time)
Tel: +416 674-5942
Fax: + 416 674-8262
E-mail: tech@lavalink.com
Internet: www.lavalink.com
Lava Computer MFG Inc.
This device complies with part 15 of the FCC Rules.Operation is subject
to the following conditions:(1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
Lava Computer MFG Inc.908 Niagara Falls Blvd.#629. North Tonawanda NY 14120-2060
that may cause undesired operation.